Viewing all customer Discussions for:

Drawer & Cabinet

Second Item on left side of Photo of Swisco image on internet appears to be similar to Souder Furniture corner bracket that I need (need 6). They are for a Souder Desk System. Thanks, Frank

Need 11 hinges or more.

What is the overall length of this adapter, and what size drill is needed if I want to install just the tube shaped adapter directly into a shelf face?

32-223What thread are the two marked holes8x32 doesn't work.Talked with Steve 11-18-2020 about this thanks

These are parts that connect to a Brookhaven cabinet side bracket. Do you carry them??

My kitchen drawers have this kind of plastic fasteners (center, rear guide). Do you something similar? Thank you! RB

Can you identify this part? There are two of them behind a pull out kitchen cabinet, one of them is broken. Do you have it and how much does it cost?

Trying to decide which one I need

Need a replacement part the the part in the picture

I need replacements for these plastic pieces that hold the drawer slides at the back of the drawers. There are no markings on the plastic pieces, but the drawer slides seem to be imprinted "UNIGRASS 6600" (it's difficult to read).Thanks for your help!Nancy

Need two (2) mounting bracket and holder assemblies

Need a replacement hinge. The plate that mounts on the cabinet broke. See uploaded photos for ID number.

This bracket fits on back of an old chester drawer. The other brackets on the set are part numbers 32-076 and 32-082. Would like to know if you have replacement. Thank you. - Paul

The left rear mounting socket cracked on a kitchen drawer - it is heavy white plastic. The glide is a Mepla MR2031/550. The brackets I have been able to find that fit the glide unfortunately do not line up with the existing holes in the cabinet back. The broken bracket measures: 1 1/4" across the ... (cont.)

Goes into back of drawer slide to stop drawer from coming out too far. I need 3 pair but the 32-081 doesn't look exactly like it.Need replacement pieces shown in photos.

This is from a drawer by Fine Furniture Design. There are no markings on the glide.

I have some older Quaker Made Cabinets. The rear sockets for the drawers have failed in a couple of them. The only markings are an R and L on the brackets. The slots measure approximately 1 inch by 3/8 inch. Attached are pictures of the right socket and a left and right one installed. ... (cont.)

I need 4 drawer track back plates that will fit guides with cross sectional dimensions shown in the photo. I purchased product code 32-089 a while ago, but the 3/8" dimension of those plates is not quite wide enough. Do you have any plates with 7/16" or 1/2" cross sectional width? ... (cont.)

This is cabinet hardware that goes on doors

Drawer Guide fits 1/4" x 3/4" track?