Viewing all customer Discussions for:

Drawer & Cabinet

This is from a drawer by Fine Furniture Design. There are no markings on the glide.

I have some older Quaker Made Cabinets. The rear sockets for the drawers have failed in a couple of them. The only markings are an R and L on the brackets. The slots measure approximately 1 inch by 3/8 inch. Attached are pictures of the right socket and a left and right one installed. ... (cont.)

I need 4 drawer track back plates that will fit guides with cross sectional dimensions shown in the photo. I purchased product code 32-089 a while ago, but the 3/8" dimension of those plates is not quite wide enough. Do you have any plates with 7/16" or 1/2" cross sectional width? ... (cont.)

This is cabinet hardware that goes on doors

Drawer Guide fits 1/4" x 3/4" track?

I'm not sure how to purchase an appropriate length

Corner cabinet hinge broke the picture is the unbroken one

The part number was 70.550-01. It is a replacement part for a kitchen cabinet

I have an old Merrilat slide, and the socket broke. I don't know if I can just replace the socket, or the whole slide. The slide that attaches to the cabinet is 22-1/2" OAL, and the slide on the drawer is the same. The socket is a bit funky, and I believe it is no longer made. If I need to replace t ... (cont.)

This is my first time needing to replace drawer slides- there were center slides, most of them split/poorly installed. Would 32-053 hold enough weight for dresser drawers, and how far out do they extend?

Do you have these clips (32-066)in clear?

IU INC or LU inc CB- 3325 1998 Canada

Here a picture of our broken brackets. Please help finding replacements. Thank you.

my drawer slide just came out and it keeps coming out. I have fixed it as best as I could, but I need something done permanently .... On the bent slide that attaches to the cabinet, it says UNIGRASS 6600 L6) It seems like it is a little less than 21 3/4". Do you have a replacement part for this? ... (cont.)

Many of thes hinges failed.A plastic piece shoots out of the hinge when they break.They have been installed for 6-7 years.The number stamped on the hinge is either,U3037.67ORU3087.67I 36 that need replacing.Thankyou,Fred

Pennsylvania House furniture bought in 2004. Drawer falls down and out because this piece is broken. 2 1/2" wide.

Please help i need to replace this Bracket

Kenlin rite-trak II. There is also the number 168 stamped on it.

Attached are photos of the socket bracket I need. The picture does not include the back of socket which I have tossed. Shelf bracket is side mounted. Any suggestions would be highly appreciated.

The drawer slider inserts into the socket and the socket can slide left to right a little inside the bracket. The slide that goes into the socket is 1 3/8" tall. I ordered part 32-003 and the slider is too big for the socket.