Viewing all customer Discussions for:

Drawer & Cabinet

Need a rear drawer track socket to match this. Any suggestions? The cabinets were installed in 1989, Mastercraft.. rail opening is 15/16th. Thanks

I am looking for a rear clamp that holds the drawer on the wood runner. Part of the plastic has broken off. Patten number is 3,201,187.It is 2 1/4 inches by 1 3/4 inches. Manufacture is Ronthor Reiss Corp NYCPlease help me find the part and let me know how to pay for it and have it mailed to me i ... (cont.)

replacing draw roller in kitchen cabinet draws

I have been unable to find any replacement pulls to fit. The holes measure 3 1/2. B 533-93 is the number located on back of one of the night stands. If you have anything that would replace these I would appreciate your help. I probably need at least 25Thanks,Suzy

I think I have your Ball catch, product code 10-057, and I want to adjust the height of the ball (lower the ball, to make it easier to open and close the door). I see the two notches, separated by 180 degrees, on either side of the casing which surrounds the ball. I presume that is where the tool is ... (cont.)

Iam having trouble finding replacement parts for these Haas cabinets. Picture included Thanks

Hi, I am looking for a replacement like this bracket. It has a hanging bracket with the white slot where the drawer rails go in. Do you have a replacement like this?

Need a rear door socket. Will this work for me?

1992 Monoco Crown Royale. Several of the rear drawer brackets are broken.

I'm looking for a replacement part for a drawer rail back mount. The inside of the rail has this on it -Unigrass6600. Hopefully I provided enough pictures to help with the search. I'm looking for about 10 of them just in case others start breaking. Thank you for your help.

The plastic slide and guide are broken on this JC Penneys Studio chest of drawers.

Hello, do you have replacement sockets for this type of drawer hardware? thanks

Need this part for a nightstand drawer slide. It is for a side mounted drawer. Thank you for your help.

On the broken glide: Ronthor Reiss Corp. N.Y. C. R-40-28 The glide was held on with staples...there were no screws. Can you tell me which replacement glide I need?

Unable to read existing hinge brand name. Probably Italian about 15 years old. Grass 170 Degree Hinge for Frameless Overlay Cabinets were already ordered with 4mm Frameless Clip-On Mounting Plates from another vendor. Diameter of hinge hole is approximately 1 and 1/4 inch. Edge of door ... (cont.)

I am looking to replace the hinges (and handles) on my kitchen cabinets. I have attached a picture of the hinge currently being used for the cabinets. The # on the hinge is 60332. Please advise if this hinge is still available. I am looking for a brushed nickel finish. Thank you. ... (cont.)

need several of these....Drawer Sockets part number # 471037

Do I need to replace the entire track system or am I just missing some kind of guide. All of the drawers look like this, and they all tip out really easily.

The broken insert for sliding bracket does not require screws. Notice that the bracket end which for the insert is slanted. Need to find insert replacement part.

Merillat cabinetry about 20 years old.