Viewing all customer Discussions for:

Drawer & Cabinet

I'm looking for a replacement part for a drawer rail back mount. The inside of the rail has this on it -Unigrass6600. Hopefully I provided enough pictures to help with the search. I'm looking for about 10 of them just in case others start breaking. Thank you for your help.

The plastic slide and guide are broken on this JC Penneys Studio chest of drawers.

Hello, do you have replacement sockets for this type of drawer hardware? thanks

Need this part for a nightstand drawer slide. It is for a side mounted drawer. Thank you for your help.

On the broken glide: Ronthor Reiss Corp. N.Y. C. R-40-28 The glide was held on with staples...there were no screws. Can you tell me which replacement glide I need?

Unable to read existing hinge brand name. Probably Italian about 15 years old. Grass 170 Degree Hinge for Frameless Overlay Cabinets were already ordered with 4mm Frameless Clip-On Mounting Plates from another vendor. Diameter of hinge hole is approximately 1 and 1/4 inch. Edge of door ... (cont.)

I am looking to replace the hinges (and handles) on my kitchen cabinets. I have attached a picture of the hinge currently being used for the cabinets. The # on the hinge is 60332. Please advise if this hinge is still available. I am looking for a brushed nickel finish. Thank you. ... (cont.)

need several of these....Drawer Sockets part number # 471037

Do I need to replace the entire track system or am I just missing some kind of guide. All of the drawers look like this, and they all tip out really easily.

The broken insert for sliding bracket does not require screws. Notice that the bracket end which for the insert is slanted. Need to find insert replacement part.

Merillat cabinetry about 20 years old.

Need to know replacement parts.

Rear mount plug for cabinet guides

I need to replace these face frame sockets. They appear to be just a hair under 4in long. What part number do you suggest? Also, the cabinet side metal tract appears to be slightly bent downward toward the rear. Is that typical or does it need to be replaced? That part is 16 in long. ... (cont.)

I ordered the wrong rear track socket pair for my Brandon cabinets. The rear drawer socket I need has an extra groove for the track to slide in. Attached is the screen shot of what I ordered, pictures of the broken socket, and the rear end of the drawer guide rail. Do you have a rear drawer sock ... (cont.)

This is from a Drexel Heritage night stand - same slide is in the dressers . Yue Xing Is imprinted on the slide.

pull handle part number on handle is either JD1056 or JO1056.screw to screw in 3 1/2 inches

The part is the exact same In all 3 pictures. It is screwed into the far end of the rail underneath each kitchen drawer. One of the parts broke off. So now there's nothing to hold a draw up when you go to pull it out.Is there anyway you can help me please.Thank you,Martin

I need a bracket that holds the rail the drawer slides on. Since these are super old and one already broke, I will buy extras if you have ones that fit.

I am missing the center metal drawer slide that is attached to the bottom on the drawer. I would like to replace the part for three drawers. Is there a place to purchase the parts? Thank you.