Viewing all customer Discussions for:

Drawer & Cabinet

We have an older home with what we believe to be StCharles kitchen cabinets. The drawer hardware has broken and the drawer is out and inoperable. We need replacement rollers if possible or the entire drawer hardware. Please advise if you can help or can tell us where next to go. Your customer servic ... (cont.)

Hi, I'm looking for these small round pop in parts that fit into a sliding door of a MidCentury media cabinet. Do you have any idea where to find those? Thank you, Michelle

I need the metal piece that goes under the drawer

Hopefully without having to drill new holes?

Left side has

Just hoping you have these brackets

Looking for the plastic rail support shown in photo....for pull out drawer.

The 340 looks as if it will work, but I want to make sure that my door will lie flat & flush when closed. The last ones we bought were the right size and shape, but there was a 1/2 inch gap between the door and cabinet.

This is the back bracket that attaches to the back of the cabinet

Do you have this part ?

This is a roller that helps the drawer come out smoothly. I'm needing to replace 4 of these. The item on your web site shows a "L" shape roller that has a roller on the side and bottom. Mine is not "L" shape. I just need the " bottom" . Do you have this part ?

This shows the metal center slide with a tape measure. The plastic slide catches under this metal slide and holds the drawer level as it is opened.Thanks. Millie

Need 6 pulls like above 4 and 1/2 inch center backside hole 1" apart

Left side plastic part needed for a bathroom vanity drawer slide.

To whom it may concern, I would like to replace my hinges for the soft close type if possible. My cabinets are from 1993 and solid cherry. They have a partial overlay with a half inch reveal. The door is 3/4" thick. The old hinges are 2 1/2" long 1 1/2" wide when closed and 2 3/4" wide when ope ... (cont.)

Can you please help me identify this hinge?

Looking for rear drawer slide brackets TATIS 5.359.752 and TATIS 5.349.723. Do you have these or a substitute?

This is from the Blum Tandem 500 drawer slide which is discontinued. The one shown is the one I have; it is mounted to the front left corner, underside of drawer bottom. I'm looking for it's partner that goes on the other(right) side of the drawer bottom. Thanks.

Looking for this replacement door pull from a Thomasville China cabinet circa mid 70's. Number on back of plate is A7752DG and A7753DC although these numbers are worn. The "C" and "G" are open for interpretation. Hope you can help.

Good Afternoon, Do you sell the part in the picture attached? If so, what is the appropriate part number to place the order?