Viewing all customer Discussions for:

Drawer & Cabinet

Need help trying to find a replacement part for the attached picture.

Would you have this part or at least the ring that snapped off of this pull?

I need 5 of these rollers. They are for a very old, not sure but counter and storage from a Dry goods type store. they are brass.

We are looking for a hinge we have 1967 pat 3319420 that is an inside mount.

Hello, I could use some help in identifying the best replacement for this type of hinge. The plastic pieces keep breaking where the hinge swings. If you don't feel you have a suitable substitute, could you recommend where else I may check? Thank you in advance for your help, Joe

Hello; perhaps you can help me find replacement parts for our cabinet door. There are 3 hinges on this cabinet and the door does not swing close (or stay closed) when manually shut. We don't have this problem on any other cabinets. Thank you!

I bought a used dresser and one the mounts needs to be replaced. I have attached pictures and was wondering if you have this type. The bracket is usable. Thank youPeggy

looking for drawer guide socket

Looking for parts to repair attached Blum Hinge

Dresser has metal stamp inside: Destinations "Century". The plastic drawer guide has broken and we cannot find a replacement part that matches. The dresser was purchased from Robb & Stuckey.

I am repainting kitchen cabinets. I want to change to silver/ nickel hinges. Photos attached. Please advise if you have a matching item. I don?t know why photos uploaded sideways. I could not change it. Please view vertical.Thank you,Ann

Need this part

kitchen drawers undermount SLild brackets

Need to get 10

Hinges appear to be brass Markings: PAT. 1967 CAN PAT #3,391,420 US Numbers 7545 on hinge part that Attaches to cabinet door No visible name Handle: brass with markings "KBC" All knobs appear to have numbers in the inside. It hard to read.

This is the right drawer slide bracket. Do not know brand.

Have a dresser that these little tabs where on each side of drawer I guess to hold level or stop drawer from falling out as you see they are busted what can use to replace thank you

I have a cracked kitchen draw bracket made by "Ferrari Lecco - Italy #B023", as stamped on the bracket. Looking to buy two sets of the brackets. Opening width is 3/8" by 7/8" height - Length from the back plate to the front of the bracket is 4 1/4". Can you help me out. Sincerely, Steve ... (cont.)

Hi, looking for the above. track is 1 inch wide (see pic of track) Hope you can help.

Like looking for a needle in a haystack lol...trying to find a replacement for that "L" shaped chunk of plastic in the pic (this an intact one I removed to find a match). Open to new slides, BUT on the old one..it has a tab to screw into the back-face (back of the front?) of drawer. Hard to describe ... (cont.)