Viewing all customer Discussions for:

Drawer & Cabinet

This is a photo of broken piece. Only identifying marking is a R i assume for right side of drawer.

Hi there - looking for 2 pairs of replacement parts for some Yorktowne cabinets that are probably 25+ years old. The drawer back plate are broken on one set and thought i should replace the other set in the cabinet. The photo is for the working set. The rail appears to be an 1" in height and the ove ... (cont.)

Please advise how I can purchase two Mepla Mepla Hinge 511.243.01.92 also 698.248.59.00 Thank you

Need to know where to purchase. I am in Des Moines iowa

Hi there I am trying to identify a piece, it is from a bedroom dresser, brand name is dynamic, it is the piece that connects the sliding door to the side of the dressor.

I'm looking for a replacement part. It is for a Merrilat kitchen drawer. I believe it's called an end bracket where the sliding piece goes into. 1" wide on inside, requires no screws, about 2" long. Do you carry this or something that would work?

Just wanted to find out what size euro screw fits the center hole? My current screw is much smaller and will not hold.

Are these compatible with all slides. I can?t seem to find replacements because my cabinets are 9 years old. I looked on all sites and do not see the ones that I have. Are there any that are compatible with all drawers?

I'm trying to replace my old hinges in my manufactured home with no luck. These have a marking of USIP No. 3205532, 3212124, 3255484, 3568241. I don't want to have to drill new hole if at possible. Any assistance you could provide me is greatly appreciated. Thank you, Amanda

I have 2 to 3 drawers in my bureau that will not close all the way. I have remove broken pieces of the 2 Items shown. Yet a few of the drawers that do close, are missing one or the other piece. I was ready to just replace the bureau which is in excellent condition but that seems ridiculous to not j ... (cont.)

need about 4 of theseSome additional details..the wording on the back of the thomasville drawer pull is D.C. 9 and A 2000

This teflon piece holds the slider for my kitchen drawer and it has broken. How can I replace with a new one? Do you have a new one for me and can you tell me how to get the old, broken one off the back wall of the cabinet. I can't figure out how to remove it or how it was installed. ... (cont.)

Part of pull on cabinet of armoir Ethan Allen Country Crossings Collection from late 1990s I have the circular handle but there is a gap between the handle and door on outside of door.

I?m looking for a cabinet hinge circa 1995. See photo. Grass 830-38 Is the name and number

we ordered the part that was recommended to replace the mepla part that was installed on our cabintets Mepla543.000. roll/x 20357572 but seems that the lip of the rail of the new part is too wide to fit into the drawer. we are at our wits end. please help.

i am in need of parts L & M for a 94339 winsome secretary desk

This is from a dresser draw. It's 2 1/2 inches wide

rear drawer socket for unigrass 6600 slide. You recommend 32-018 rear drawer socket. other comments and the photo show a straight socket. the broken ones are slanted but do not have a product number. John

Looking for the replacement. Plastic or metal

Rail seems to be 7/8 by 1/4