Viewing all customer Discussions for:

Drawer & Cabinet

Center mount drawer guide with wheel. Attaches to guide bar.

Hi, I'm hoping you can find me a pair of replacement drawer slide sockets based off the measurements on the attached pictures. There's no numbers on the sockets or slides. Thanks, Matt

I need a set (left and right) of the drawer glides that would fit my Prepac Astrid 4-Drawer Dresser.The glides are approx 11" long. I am ok with substitutes as long as I can figure out how to affix them.

Do you have a part that will attach this front securely but still allow occasional accessibility? This is a space under my double ovens and I also have a larger one under my raised dishwasher.

Hello, I hustled purchased 4 slides that were the wrong size. The opening I need is 3/4 in.

This is from a mobile home drawer..

The installed piece is the left side of the drawer. The rusted piece that I need to replace is for the right side. I've been to several hardware stores and they can't help me.

This is a pull from a dresser, brand not identified anywhere on the piece. It is 3-1/2" on center. The back of the handle is marked with "KBG1" and "K9155" ? can you help? If replacing the exact part we need 2; but if replacing all we need a total of 10. Thanks!

Hardware is attached to the back of a vanity drawer handle panel. I'm hoping to replace the broker hardware so the drawer will work again

Juhua is the brand name I believe

Do u happen to have any of these? If it?s off waterbed drawers. I know....old school. Lol. It?s 2 1/4?

Looking for a replacement for the socket one a 1? rail. The right side shifts when opening or closing the vanity drawer which cause the glide to slip out of the track. Vanity was installed in Spring of 2017.

I purchased 32-119 Grass adapter rear mount brackets. Found that the slides are bent. (adapters fit) I am not sure what size to purchase for slides. The inside slide is 23L, the slide mounted on drawer is 22L. The height of slides are 1" but 1 1/8" at ends. There is a "G*" to the left of the inside ... (cont.)

the wheel on this side fell off. I need new set i guess. they are 16 inch long. Do you have a replacement for this?

Rear plastic mounting bracket for drawer slide

The wheel on one of the slides is broken (see Slide JPG). I would like to order a replacement of the slide. I also have included a photo of the drawer and the bottom rail on it (see Drawer JPG), if that is helpful for identification. The photo is upside down (oops) but hopefully you can see the ... (cont.)

Hi looking for 8 units . They come from wood-mode drawer sliding .

The part height is 2.25 inches n less than inch across. The photo backside has broken peg toward lower end. Takes 4 of these clips to hold one shelf in place! Thx!

Looking for plastic guide piece that keeps door inside runners at top.

Pictures are of drawer hangers that are from cabinets made by Welborn. I am told that the brackets were made by Tenn-Tex plastics. They do not make them any longer. They suggested Swisco as a possible source. The cabinets date from about 1992.