Viewing all customer Discussions for:

Drawer & Cabinet

Do u happen to have any of these? If it?s off waterbed drawers. I know....old school. Lol. It?s 2 1/4?

Looking for a replacement for the socket one a 1? rail. The right side shifts when opening or closing the vanity drawer which cause the glide to slip out of the track. Vanity was installed in Spring of 2017.

I purchased 32-119 Grass adapter rear mount brackets. Found that the slides are bent. (adapters fit) I am not sure what size to purchase for slides. The inside slide is 23L, the slide mounted on drawer is 22L. The height of slides are 1" but 1 1/8" at ends. There is a "G*" to the left of the inside ... (cont.)

the wheel on this side fell off. I need new set i guess. they are 16 inch long. Do you have a replacement for this?

Rear plastic mounting bracket for drawer slide

The wheel on one of the slides is broken (see Slide JPG). I would like to order a replacement of the slide. I also have included a photo of the drawer and the bottom rail on it (see Drawer JPG), if that is helpful for identification. The photo is upside down (oops) but hopefully you can see the ... (cont.)

Hi looking for 8 units . They come from wood-mode drawer sliding .

The part height is 2.25 inches n less than inch across. The photo backside has broken peg toward lower end. Takes 4 of these clips to hold one shelf in place! Thx!

Looking for plastic guide piece that keeps door inside runners at top.

Pictures are of drawer hangers that are from cabinets made by Welborn. I am told that the brackets were made by Tenn-Tex plastics. They do not make them any longer. They suggested Swisco as a possible source. The cabinets date from about 1992.

I have what looks to be A Grant DR.

Looking for replacement pulls. See images

measurement from screw in holes to front of bracket: estimated @ 4 2/16"

I am showing the right side only The piece that mounts in the cabinet measure 23 inches The piece that mounts to the drawer measure 19 5/8 inches Please let me know the replacement part number so that I could order it ASAP thanks

Would you take a look at my picture and see if I have the right part? It seems right. Thx.

It looks like they are about a 1" roller with a bearing and shaft. I have two that have been turned into cams instead of wheels! I'm also looking to replace the nylon latch insert that keeps the cabinet closed. I have resorted to using magnets, but if you have the nylon latch, I would totally repl ... (cont.)

It seems like there are predrilled holes in the cabinets that the brackets fit into. I dont know if I need these exact ones or if I can just use a different replacement?

Hello Can you tell me what part I need to replace the broken parts

Vaughan Bassett dresser drawer part needed to close drawer.

Hope you have something like this. The picture should be rotated so that the slide is located on the bottom rail. The drawer rests on and rolls on the small wheel. There is a center mounted rail for the drawer. Any help would be appreciated.