Viewing all customer Discussions for:

Drawer & Cabinet

Rear plastic mounting bracket for drawer slide

The wheel on one of the slides is broken (see Slide JPG). I would like to order a replacement of the slide. I also have included a photo of the drawer and the bottom rail on it (see Drawer JPG), if that is helpful for identification. The photo is upside down (oops) but hopefully you can see the ... (cont.)

Hi looking for 8 units . They come from wood-mode drawer sliding .

The part height is 2.25 inches n less than inch across. The photo backside has broken peg toward lower end. Takes 4 of these clips to hold one shelf in place! Thx!

Looking for plastic guide piece that keeps door inside runners at top.

Pictures are of drawer hangers that are from cabinets made by Welborn. I am told that the brackets were made by Tenn-Tex plastics. They do not make them any longer. They suggested Swisco as a possible source. The cabinets date from about 1992.

I have what looks to be A Grant DR.

Looking for replacement pulls. See images

measurement from screw in holes to front of bracket: estimated @ 4 2/16"

I am showing the right side only The piece that mounts in the cabinet measure 23 inches The piece that mounts to the drawer measure 19 5/8 inches Please let me know the replacement part number so that I could order it ASAP thanks

Would you take a look at my picture and see if I have the right part? It seems right. Thx.

It looks like they are about a 1" roller with a bearing and shaft. I have two that have been turned into cams instead of wheels! I'm also looking to replace the nylon latch insert that keeps the cabinet closed. I have resorted to using magnets, but if you have the nylon latch, I would totally repl ... (cont.)

It seems like there are predrilled holes in the cabinets that the brackets fit into. I dont know if I need these exact ones or if I can just use a different replacement?

Hello Can you tell me what part I need to replace the broken parts

Vaughan Bassett dresser drawer part needed to close drawer.

Hope you have something like this. The picture should be rotated so that the slide is located on the bottom rail. The drawer rests on and rolls on the small wheel. There is a center mounted rail for the drawer. Any help would be appreciated.

First 2 photos are of the hinge that I need to replace on the cabinets upper left. The others are to show the non broken lower right one fir dimensions. I?m looking specifically fir this hinge. I can?t figure out where it by whom the medicine cabinet was made as it is old. Do you only have the two h ... (cont.)

Sorry about the poor photos of the part in place. The two clearer photos show the broken plastic part that belongs on the back wall of the cabinet. It's an old HAAS cabinet. Do you have a replacement part?

What is the load capacity of the 32-096 roller?

Hi , I'm looking for 35 of these hinges . Price and availability please . Thanks Bill