Viewing all customer Discussions for:

Drawer & Cabinet

I need one of these so I can have my bookshelf all put together without having to Jerry-rig something. I appreciate any info you may be able to provide. Thanks,Mike

Do you have any parts like this

The dresser is about 30 years old. The slide is attached with staples. Thanks, Anna

This is the broken wall mount to hold shelf rails in place.

Hi, glad I found this site! My guide is very similar to 32-031, however my opening between tabs that slides on track are larger than 3/4". It appears to be closer to 1". All the other measurements are the same.

Need a replacement part The pictured one is broken

i purchased the same drawer guide about 1.25 years ago. I would like to buy a four of these. the home was built around 1989 and the guide attaches to the back of the drawer space and the metal arm over which the drawer glides goes between the upper and lower parts of the guide where it broke. ... (cont.)

Hi, I received my rear mounting brackets but they don't work with my drawer guides. The replacement is a straight channel and the original is a bit wider with a lip to accommodate the slight bend in the drawer guide. What do you recommend for a replacement? I've attached a photo of the drawer guid ... (cont.)

Looking for hinge for corner cabinet with lazy Susan. It is the hinge that connects the door to the cabinet. Made in Austria. Several part numbers - some on hinge components, some on plates.

Need brackets in photo

Looking for this drawer slide

I'm looking for four replacement handles.

I am looking for drawer slide rollers with ball bearings for metal cabinets. Some of the current ones have flattened on one side causing the drawers not to open and close smoothly. Since I am repainting these cabinets(2) I wanted to replace the drawer slide rollers but have been unable to find them ... (cont.)

this is for epoxy coated side mounted slides. it mounts into the 2 holes in the back of the cabinetW= 1 1/8L= 1 7/8slot for slice= 7/8pegs= 1 1/4 on center

Can't find these.... do you have these?

I NEED ONE (OR A PAIR IF SOLD THAT WAY) OF THESE AMEROCK HINGES. I COULD ALSO GET BY WITH JUST THE "T" SHAPED PART IF YOU HAVE ON IN THE BOTTOM OF A DRAWER OR BIN. THANK YOU! JOE

Lescoa 9300 is enscribed on the stop locks Photos are of broken part and drawer slide that attaches to it

I need the plastic piece at the end of the rail.

This is the bracket we need two for a drawer. Our cabinets are made from Wellborn company

This is the right side rear mounting breaker for a kitchen drewer