Viewing all customer Discussions for:

Drawer & Cabinet

I need a replacement hinge for a Mepla 674.305.53.00. Do you have one?Thanks,Jon

I don't know why picture rotated but that is bottom of drawer The part is plastic about an inch and a half or two inches Curves up a little. I saw on your site a black similar one for the top of drawers but was wondering if you had one like this Thank you so much

Hi,Do you have an Australian distributor ? I have a customer who needs some of these replaced.Many thanksOwenHandyman

Need to purchase dresser knobs

Please I've been looking for years! Thank you. I need 6 for a beautiful old fashioned dresser.

Hi, aristokcraft bath vanity - false front panel - 2 clips that hold panel in place need replacing. 2 little plastic clips hold the panel in place. One chipped and need to replace both clips. Thanks for the help. Dan

Just purchased 9 rear drawer guides, 32-031, thought I had measurement down but I was wrong. Here is a picture for what I'm after. I need 9. Can you help us or give us a lead?

I inherited an old Kobalt tool chest, the wheels on some of the drawer slides were completely seized. I am glad I found your website, I replaced them with 3/4" Flat Shower Door Wheels, it works like new.

ronthor reiss corp nyc part R-40-23 for back of drawer bracket

I have Scheirich cabinets. I need the track for the drawer. The part number is PPW099. Can you help me? Thanks Gary

Can you help me find the correct hardware? Older kitchen cabinets Looks like a chunky letter L. 2" x 2 1/4 Longer side is for slide. 1 1/4 wide.

Drawer back plate ?

The piece show is plastic and has snapped. It keeps the drawer tracks in place at the front corner of the drawer.. I need two LEFT side and 4 RIGHT side.

Hello, I am looking for replacements to this hinge, can you please help me with this? Thank you, Courtney

Looking to replace both left and right rear socket mounts. Ferrari is the manufacturer of the original parts. I also need any other hardware necessary for installation.

This is the part that fits on the drawer. As you can see the little wings have broken off

Undermount kitchen drawer rail back support brike off. Can you help identify brand and sell me parts? Looks like plastic support fits into hole on steel back support? Thanks. Tom.

Its a small rectangular plastic piece that is glued to the bottom of the frame where the drawer slides on when opening and closing the drawer.

Attached is a good drawer. I have 2 others where the wheel and mount are broken. It uses a top center mount slide.

the black plastic insert part cracked in our top cabinet hinge? it is labeled 698.256.53.00 ? any idea where we could find one? Thanks!!