Viewing all customer Discussions for:

Drawer & Cabinet

Just purchased 9 rear drawer guides, 32-031, thought I had measurement down but I was wrong. Here is a picture for what I'm after. I need 9. Can you help us or give us a lead?

I inherited an old Kobalt tool chest, the wheels on some of the drawer slides were completely seized. I am glad I found your website, I replaced them with 3/4" Flat Shower Door Wheels, it works like new.

ronthor reiss corp nyc part R-40-23 for back of drawer bracket

I have Scheirich cabinets. I need the track for the drawer. The part number is PPW099. Can you help me? Thanks Gary

Can you help me find the correct hardware? Older kitchen cabinets Looks like a chunky letter L. 2" x 2 1/4 Longer side is for slide. 1 1/4 wide.

Drawer back plate ?

The piece show is plastic and has snapped. It keeps the drawer tracks in place at the front corner of the drawer.. I need two LEFT side and 4 RIGHT side.

Hello, I am looking for replacements to this hinge, can you please help me with this? Thank you, Courtney

Looking to replace both left and right rear socket mounts. Ferrari is the manufacturer of the original parts. I also need any other hardware necessary for installation.

This is the part that fits on the drawer. As you can see the little wings have broken off

Undermount kitchen drawer rail back support brike off. Can you help identify brand and sell me parts? Looks like plastic support fits into hole on steel back support? Thanks. Tom.

Its a small rectangular plastic piece that is glued to the bottom of the frame where the drawer slides on when opening and closing the drawer.

Attached is a good drawer. I have 2 others where the wheel and mount are broken. It uses a top center mount slide.

the black plastic insert part cracked in our top cabinet hinge? it is labeled 698.256.53.00 ? any idea where we could find one? Thanks!!

Hard plastic-no identifications. 2" x 2 1/4 Looks like a chunky L 1 1/4" wide

I need drawer slides for an old Quaker Maid cabinet, back when they were made in Leesport, PA. They are either 19" or 21 1/2 ". Any hope for me? I could also use 7 magnet kits for the doors.

This piece fits at the top of the closet door and connects with a metal piece in the door jamb. There was a metal ball in the piece in the photo but is missing. Help! Thank you

Need help replacing these old hinges. Any suggestions.

need four of these

I have ordered 33-070 and it is too short and wide, then 33-108 which is the right length but too narrow. This is for an assembly to replace a Mepla 600.010.08.25 wall spacer for sliding drawer shelf. I will try to fix using the 32-339 drawer slide spacer. I also need some flat head Phillips scre ... (cont.)