Viewing all customer Discussions for:

Drawer & Cabinet

Hello, I have been looking for a couple of these for quite some time. It has very few markings on it, Pat. 1067, I think, kind of hard to read the numbers. Below that is the word RAM, I think. On the center of the hinge it says A8. They are from some cabinets that I cannot find any names on them, bu ... (cont.)

Looking for hinges with same but in brush nickel

Your request (36393337) has been updated. To add additional comments, reply to this email. My husband sent me this to respond to as he can't send pictures. We just can't figure out how to re-assemble the slides and put the drawer back in correctly. I think it is missing parts. Thank you. Susan & Ru ... (cont.)

Hi- Hope you can help. I have a broken glide on my early 60's dresser that need replacing. I have attached a photo of a broken and not broken for comparison. Is this a part that you have or is there something you can recommend. The part holds the dresser from shifting left to right and the smal ... (cont.)

Will these lock in place so drawer won?t slide out during travel

Hi Swisco, Looking for another part for a lab table drawer, it's kind of a push in to pop open the drawer type of opener, so don't need a handle on the drawer front. It's adjustable by turning the plastic screw/bolt (to keep the drawer flush with the front of the cabinet) that hits on the back of th ... (cont.)

Drawer bracket .

Hello! I am looking for a replacement hinge on a kitchen cabinet as shown in the picture. Any help would be greatly appreciated.

I am looking for a drawer socket. It is brown plastic. Only R and L on the parts. It has a gap width of 0.5", a gap height of 15/16", and a length of 3.5".

I need 4.

Need replacement hinge for this patented hinge. Saw suggestions on website but was unsure if the recommendation worked out.

Need replacement hinge for this patented hinge. Saw suggestions on website but was unsure if the recommendation worked out.

I can not find this exact piece. It is not a ball bearing or two-piece roller. It's just a single piece of plastic.

I need a couple of these parts for drawer slide holder

I am trying to fix some closets and I need to take off the closet doors in order to do so. Some of the hardware is broken, so I thought I would replace some as I go along. I am unable to remove the doors because of this hardware, and I need some advice.

Need the inside we're the track fits to be 1". Doesn't seem to be available at local hardware or big box stores.

Good afternoon, I am looking to purchase 2 kitchen cabinet hinges, part number 698.256. I am attaching 2 photos of the item. Thank you in advance. Please advise of price and how quickly I can receive the parts.

What is the dia of the Pin or axle?

Part that holds side of drawer up. Each side of drawer slides on one of these. There's a piece of it that's broken off plus it has the number 6 on it.

Hello,I am in search of a replacement kitchen cabinet drawer slider guide. I found some similar but not quite the same. I have attached pictures of the broken piece, as well as one that is in place and not broken. If you have any suggestions for replacements please let me know. Thanks,Annette ... (cont.)