Viewing all customer Discussions for:

Drawer & Cabinet

My rear draw sockets are 25yrs old and I cannot find ones with the same measurements do you have any that might work?

Is there a drawer pull same as 4-1/2" PULL HANDLE Product Code: 22-201, in a 4" center to center? I need both sizes and would like them to match.

If you unscrew the insert inside with the ball and spring, what?s the diameter over the threads and what pitch is the insert? And also what?s the diameter of the ball? Thanks Pete

Hello looking for kitchen cabinet door hinges german made 346.290.5103 or 674305530077 thanks al

hi there, I need a replacement for teh attached pictured closet door guide. It has a "Sterling" logo, but no other identifiers. House was built in '81, this is probably original. I need 4-5 of these?

I need 3 sets of these rollers

I purchased a grass adapter bracket pair, 32-119 (order no. 1229010), however this did not work. I have attached a

How thick is the drawer stop? I want to make sure it will fit through the gap my drawers have

No much information about it

I am in need of this piece of hardwear.Would like to know if i can buy this part or am i at a lose with this

View which faces rail and attaches to rear wall of cabinet. View of back which faces side of cabinet. James

I have attached one photograph of the back-plate for a wood drawer slide from a Pennsylvania House unit purchased in 1980. The track-opening measures 1-1/8" W x 1/4" H. The rectangular section is 2" W x 1" H, and the integral trapezoidal part is 1" H. I note that Swisco product code 32-031 differs ... (cont.)

Hello I am searching for the top and bottom rail for two sets of closet doors. The closet door with the two little rollers that are attached I need the top rail for that particular unit in a 48 inch top and bottom rail. For the larger door with a plastic guide I need the top and bottom rail in a 60 ... (cont.)

what is length dimension of this hinge. the current one on armoire is 8.25 inches. photos previously uploaded

no markings on any of the three pieces. The third piece is the one glued in the back of the cupboard that supports the stationery slide. These pieces do not attach to the wall. There is a space between the slide and the wall

Looking for 4 hinges, 2 each for a steelcase models X2B023757 AND X2B032753. Hinges mount to a drawer slide mechanism to allow the door to slide into the cabinet when opened. hinge has 654 325 53 00 on it base pieces show 301 290 50/00 and 59129000/00

Old, ANGLED plastic drawer slide boss, often stapled in place, back end of drawerWould prefer messaging, if possible... Can send photo, if you want...

I am looking at the rear drawer guide (Product Code 32-031) and wondering if this comes with different track opening sizes.

Hope the additional images are helpful. Opening for Bracket rail is one and an eight inches. Height is 1/2 ". Thx for your help.

Here is a picture of the dresser handle. If you have a replacement please advise me. Thanks, Don Johnson