Viewing all customer Discussions for:

Drawer & Cabinet

Hard plastic-no identifications. 2" x 2 1/4 Looks like a chunky L 1 1/4" wide

I need drawer slides for an old Quaker Maid cabinet, back when they were made in Leesport, PA. They are either 19" or 21 1/2 ". Any hope for me? I could also use 7 magnet kits for the doors.

This piece fits at the top of the closet door and connects with a metal piece in the door jamb. There was a metal ball in the piece in the photo but is missing. Help! Thank you

Need help replacing these old hinges. Any suggestions.

need four of these

I have ordered 33-070 and it is too short and wide, then 33-108 which is the right length but too narrow. This is for an assembly to replace a Mepla 600.010.08.25 wall spacer for sliding drawer shelf. I will try to fix using the 32-339 drawer slide spacer. I also need some flat head Phillips scre ... (cont.)

I don't have the cabinet brand but the metal slide is stamped unigrass 6600. I don't need the slides, just the plastic end the slide fits into. I need both left and right

I'm looking for the closest thing to this old hinge in stainless or silver color. The length of the part of the hinge that attaches to the cabinet is 2 7/8 inches (top to bottom) and about 7/8 inches (wide), and the length of the part that connects to the door is 1 5/8 inches (top to botton) x 1 1/ ... (cont.)

Need replacement hinges for medicine cabinet. Cannot find any info about manufacturer. Cabinet is 23" wide, 29 1/2" high.

Hello and apologies that these are mounted on the cabinets. Trying to find a nickel finish replacement for these that will be a simple swap out. Can't seem to find one with the single hole that is against cabinet frame. Many thanks!

Slider on the drawer side of 5 drawers were bent and hard to open. Existing sliders have a smaller roller/wheel. Hoping to find a replacement for the drawer so I do not have to replace both sides. Cabinets were installed in 2004 There are no markings visible on sliders. Appreciate any assistan ... (cont.)

These are broken on my mother's bathroom drawers, please help me find replacements. thank you

nylon; 29/32" diameter; 1/4" wide with a stub mount

Looking for plastic drawer Guides for a going home collection night stand.

I need the slide tongue or a replacement back bracket for this 22" Center slide rear mounting slide.

I have a plastic track that measures 3/4 inch. Will this 32-031 guide work? If not what would you recommend? Thank you

There are no names or numbers on the item. The drawer back is .410 thick and the slide held on with a small staple. It was used on Bassett furniture in the 60's.

I've been to several hardware stores trying to find a drawer glide that will work with drawers in my kitchen that have had the glides break. I need a glide to mount at the back of the opening which will support the track that holds the drawer. I've attached some pictures to give you an idea of wha ... (cont.)

Good morning we had the bracket for a drawer void break . I've looked and looked nobody has them. I ran across your site and I'm Hoping you can help I've take pictures of the face and brackets and up loaded. Thanks for your help