Viewing all customer Discussions for:

Drawer & Cabinet

One on each side of kitchen drawer with a 1/4 inch post and a1/8 inch anti spin pin , plastic

This is the clip that secures the drawer to the slide rail.

It's an old part usip code no. 3212124 or 512124 can't see well the first number I need 35 units

I need a rear guide to fit a 1 inch metal guide. You will see one is broken on the right side. I need 3 sets of rear guides

Delta Industries - CA. LA. SER. 50 1 Rear Drawer GuideTrying to locate these rear kitchen drawer guides. The slide into a rail that holds drawer in.

This is from a dresser made by Vermont Tubs in approximately 2003. The mounted piece is 10.5" long and the slide part is 16" long (not extended). There seems to be a plastic part on the bottom that has failed. The drawer will not catch and stay closed. Image 9452 is an installed piece on a closed ... (cont.)

Hi! I have old cabinets that I just painted. This is a picture of the hinge. Someone mentioned it might be called an A1? Not sure if that is right. Do you have this hinge in satin chrome? Or what finish do you have this hinge? Kelly

Where I found this part because I need one. Thanks

These Merilatt cabinets were installed in 1994 and the plastic clip parts have not held up, as you can see. I would, however, like to replace just the broken clips for five drawers and five sliding shelves, if that is possible. I have photos on my phone. Is there a number or email where I could s ... (cont.)

Looking for this item or replacement. This is the rear socket guide for a drawer with bottom center drawer guide.

I am in need of a MEPLA "European" cabinet hinge. As near as I can figure the number is 501-2.75

Hi, The front right corner bracket on one of my pantry sliding shelves broke. The remaining brackets are fine; however, I need to find a replacement for the broken bracket, but I'm not sure where to find it. The first three pictures are of the broken bracket. The last picture is of the unbroken ... (cont.)

Take a look at our 32-031 rear drawer guide and see if our measurements line up with yours.

I am looking for this part that goes on a dresser drawer. Can you help me?

I hope that you'll be able to identify this hinge I'll need Ten of them

Looking for 2 right and 2 left rear brackets that hold drawer glides in place. Kitchen cabinets were made by Merrilat

Hi can you identify this part I can't seem to find it anywhere. The only markings on it is the name REISS. it sits on the top edge of the back top part of the drawer so when the dryer is pulled out it serves as a spacer in a slide against the bottom of the drawer framing above it ... (cont.)

identical to your 32-012 except does not screw to secure snaps into rear cabinet wall holes !

Hi there, Looking for replacements for some Ferrari drawer sliders. The left slider appears to be model "GS13" and the right slider is "GS11", pictured The drawer hole opening is 21" wide by 9" height. The drawer itself (not the drawer face) is 20" wide by 8.25" height. This means that there is ap ... (cont.)

No letters or numbers. Tv cabinet with two folding doors. Two hinges oer cabinet. Four totalAs shown approximately 3" across and 2" tall