Viewing all customer Discussions for:

Drawer & Cabinet

Need 2 sets of these. Drawer slides for back of kitchen drawers.Thank youJoan

want to replace slides in std 24" deep cabinet, so 22" slide should work, probably 80's vintage. Also need plastic rear bracket/socket mounted to back of cabinet. Existing bracket has dowel which goes into hole in cabinet back. A bracket with just screw holes would do. Slide is almond, but white ... (cont.)

Good evening,I am looking to see if this is a product you may have produced. I am looking to replace 4 handles. This came off a Lexington Victorian bedroom suite. Purchased in 2001.Let me know if you need any additional information or pictures.Thank you,Sara

Drawer guides are 11 3/4 long

Thin nail with a plastic disk as a head. This round flat piece allows the drawer to glide smoothly when opening and closing.

Plastic piece on drawer slide is broken. Do you have replacement piece?

Looking to order 6 of these brackets, 3 left and 3 right. Do you have them in stock if so how can I order them. Thanks

Looking for (2) drawer pulls for my vintage thomasville homecoming collection dresser. See pic.

I need two hinges Mepica #511.356.00.25. Can you help me to find it?

This is a picture of the broken part still attached to the cabinet. a corner is broken off and the slider bar falls out. i need a replacement for this do you have it. Thank you in advance for your help.

I have looked most everywhere for replacement hinges but the screw holes won't match up. It appears similar to 32-340 except the holes you have marked as 2 1/32 apart are 1 7/8 on my old hinge. Your diagram shows these holes off set from center and near the corner of the bracket which is the same ... (cont.)

I have the USIP hinge with no offset, the flat part is 1-5/8 wide and from the bend to the edge of the flat plate it is 1-3/8. I need 96 of them in brushed nickle. the patent numbers are 320532,321214,325484 and 3568241 the distance between centerline screw holes is 2-1/8

For a kitchen drawer.

Do you have any hinges like this one?

Spoke to guy from kitchen place. He provided part numbers. It is a plastic part which is butterscotch in color. I need the left part that holds that track. You can see that is broken at the bottom.

One inch wide opening.

On set of kitchen cabinets approx. 40 years old

Hello, I'm looking for a replacement for this. It is installed on a chest of drawers sold by Bassett furniture about 10 years ago. Thanks for your time

Looks like the serial number is 30.310 11.02 PA 66 Do you have these? Thanks

Do you have a roller, like part 32-121, in a single roller? I need just the bottom roller for my waterbed drawer.