Viewing all customer Discussions for:

Drawer & Cabinet

This is slightly similar to 32-345 but not with an L-shaped section. Please help me identify it. I have 4 of them on one cabinet and one is broken. I need to replace it and have 1 or 2 spares. I can have it shipped to Fort Lauderdale if you can't ship to Canada.Thanks,Rick

need end rail plastic pieces.montgomery woods complexthanksbill

I have four broken kitchen drawer brackets with the above number stamped on them. How can I get a replacement. I do not have a photo but if you google it, the image will show up. It is a tan clip in piece that receives a drawer slide.Thank you, Steve

My dresser drawer won't close all the way. The part noted in the photos above broke off. I suspect it impacts the ability of the drawer to close completely. ??? The dresser is a Thomasville. Any idea what part I should try to purchase?

Need 2 sets of these. Drawer slides for back of kitchen drawers.Thank youJoan

want to replace slides in std 24" deep cabinet, so 22" slide should work, probably 80's vintage. Also need plastic rear bracket/socket mounted to back of cabinet. Existing bracket has dowel which goes into hole in cabinet back. A bracket with just screw holes would do. Slide is almond, but white ... (cont.)

Good evening,I am looking to see if this is a product you may have produced. I am looking to replace 4 handles. This came off a Lexington Victorian bedroom suite. Purchased in 2001.Let me know if you need any additional information or pictures.Thank you,Sara

Drawer guides are 11 3/4 long

Thin nail with a plastic disk as a head. This round flat piece allows the drawer to glide smoothly when opening and closing.

Plastic piece on drawer slide is broken. Do you have replacement piece?

Looking to order 6 of these brackets, 3 left and 3 right. Do you have them in stock if so how can I order them. Thanks

Looking for (2) drawer pulls for my vintage thomasville homecoming collection dresser. See pic.

I need two hinges Mepica #511.356.00.25. Can you help me to find it?

This is a picture of the broken part still attached to the cabinet. a corner is broken off and the slider bar falls out. i need a replacement for this do you have it. Thank you in advance for your help.

I have looked most everywhere for replacement hinges but the screw holes won't match up. It appears similar to 32-340 except the holes you have marked as 2 1/32 apart are 1 7/8 on my old hinge. Your diagram shows these holes off set from center and near the corner of the bracket which is the same ... (cont.)

I have the USIP hinge with no offset, the flat part is 1-5/8 wide and from the bend to the edge of the flat plate it is 1-3/8. I need 96 of them in brushed nickle. the patent numbers are 320532,321214,325484 and 3568241 the distance between centerline screw holes is 2-1/8

For a kitchen drawer.

Do you have any hinges like this one?

Spoke to guy from kitchen place. He provided part numbers. It is a plastic part which is butterscotch in color. I need the left part that holds that track. You can see that is broken at the bottom.

One inch wide opening.