Viewing all customer Discussions for:

Drawer & Cabinet

Hello! I have a 7 draw dresser, that the stops which I have enclosed pictures of have worn over time and now are not stopping the drawers. When my 8 year old daughter pulls the drawer out it falls out of the dresser because the drawers are very heavy. I am hoping you are able to identify the part ... (cont.)

I need a few cabinet drawer slider brackets. These fit in the back of the cabinet and support the slider track. I have attached picture for you. Please see if you have these or something that will work and I will get back to you on how many I need.

Attached is a more detailed picture and measurements of a previously submitted picture. Your expert asked for measurements and I could not figure out how to respond to that request so here is a new pic.

I need help locating a replacement part for 510 356 00 13. Any help would be appreciated.

Need 4 pair back bracket need to be 4 & 1/4 in long to fit existing hardware

Hi we have the unigrass6600 pull out drawers. The brackets that hold the rails in the back broke. The model # inside then says 471037. Can you please tell me which replacement item will work to fix them. Thanks!!

I have a bottom mounted cabinet drawer in my kitchen which has a single track slide in the middle. My wife pulled the drawer hard and now, the drawer comes out all the way without stopping. I looked deeper and saw that there is a part that is attached to the drawer (at the very back side of the tra ... (cont.)

We have a pantry cabinet with 12 slide our shelves. The spacers on the shelves with the heaviest loads of failed. I'm wondering if you think the 1" DRAWER SLIDE SPACER Product Code: 32-339 is a good replacement. It looks like it should work. What do you think? And are these spacers made of more ... (cont.)

Might you have the attached Mepla Part # 348.258.00.35 / 9M hinge?

Need to order these---how much?

Hello, here are two pictures of the replacement part i need. thanks

I need a replacement for this piece. I'm sure it's no longer manufactured so I need one that will work from your catalog.

I just purchased a used BroyHill Attic Heirlooms captains bed with 7 drawers and a Wardrobe with 3 drawers. The drawer slides are shot (sloppy and broken plastic runners and sockets)... I need replacement parts or full assemblies. The drawers range in depth from 8" to 18". Do you have/carry the par ... (cont.)

I'm looking for this part for my son's dresser, do you have anything like this photo attached? I can't seem to find it. Thanks.

this piece is inside of a cupboard attached to a pull out shelf. the two front drawer extensions broke.

I am missing 2 of this corner slider glide. Any Idea where I can find them

Parts for UNIGRASS 6600 sliding drawer: part 1: 1 white round rubber spacer and part 2: 1 rear mounting bracket plastic white

Hi, we are looking for a bracket to hold up the right drawer track in the back of the cabinet. The one we tried (The white one in the photo) offered a very temporary solution. Duck tape was involved! The one on the left is the correct piece. You'll see the measuring tape next to it. I hope that help ... (cont.)

The part is from a Bassett bedroom dresser. It is white plastic at the end of a dresser drawer that keep the drawer from falling down when you pull it out. Is is about 2 3/8" wide at the top. The opening for the guide rail is about 1 1/8". Notice there is an opening for the guide rail and anothe ... (cont.)

Kitchen Cabinet drawer. 77-21395 is a possible part number. The company went out of business and this piece broke. Thank you for your help!