Viewing all customer Discussions for:

Drawer & Cabinet

Hello, I have drawer sliders which are marked with G* (asterisk) and they are soft close slides with a spring in the rear to pull the drawers closed. The spring on one of the slides broke and now the drawer doesn't pull closed like it should. The slides were marked with; 500 440 E 500 4616 ... (cont.)

Hi, My drawer sliders on several drawers have broken and I can't find similar ones anywhere! The parts that have broken are what I have shown in the pictures the drawer slides are center mount and the 1st picture is the bottom rail attached to the cabinet - the plastic piece has broken (pictured i ... (cont.)

Replacement hinge.

I'm looking for rollers for this late 1950s kitchen drawer. Your 32-096 roller looked like it would work, but the roller width (9/32") is to wide. Is there anything thinner?

One is broken through per attached photos. The left mate is cracked and needs replacement. Looks similar to Patty's, but not sure, and there's no part number identification stamp. Just the Ferrari brand Thank you!

This parts under the drawer of a self closing type

where can i find this manufacturer/part...drawer spacer? thanks Eric

Plastic piece says Ronther Reid's Corp NYC R-40-28 Pat. No 3.201.187 the furniture is in excellent condition except this part is broken on every drawer. Please assist in finding the proper replacement part. Thank you!

Hello. Would like to known what type of shelf bracket this is and if you still make and/or sell it? This was in a kitchen cabinet in a 1985 home so was a little worried I wouldn't be able to find it anymore or something similar to it that would work. Any information would be greatly appreciated. ... (cont.)

Would like to get a part that matches pic. Thanks

The nob on the back of my drawer slider bracket snapped off. I do not have a picture of this bracket. The measurements are very close to these figures: nob to front-1 15/16", inside opening: top to bottom-15/16", top width-7/16", bottom width-5/16". I've looked all over for this and can not find ... (cont.)

I need replacement rollers for the lazy Susan portion of a St. Charles Kitchen cabinet. The rollers are 1 1/8 inch tall and 1/4 inch wide. I have attached a couple of photos.

Hello, I live in a house with cabinets from the 1980s. At some point someone replaced the proper older back wall attached cabinet drawer slide bracket with a cheap, square one that has broken. I am attaching a picture of the one that remains (and that matches most of the other remaining brack ... (cont.)

We have a few that need to b replaced.

I am looking for a rear cabinet mounting bracket the one I have is a white the the plastic peice measures 1inch x 2 1/4 inches .any of your products match these dimensions ?.the one inch is where the roller rides on .I have been looking for this type of part for 2 years I'm glad I found your site bu ... (cont.)

This is for a drawer that hangs below a board in the back of the cabinet

Back of drawer in middle Part is broken need replacement Part reads "hardware designers inc. number 462"

Need 1 1/4" white.

Hello! My house was built in 1985. Painting my kitchen cabinets and replacing the hardward. Cannot find this hinge anywhere (with the reversed holes for attaching to cabinet door). Can you help? [see attached images] Thanks! Jene'

bracket is 2 1/2" wide and 2" high. Bottom part is broken. Is r4028 the replacement?