Viewing all customer Discussions for:

Drawer & Cabinet

Unfortunately no part numbers I can find. This inserts into metal strip attached to rear of the drawer opening. Thanks for any help you may be able to provide.

Could you afford me the exact measurements

Hi, I'm looking for a replacement bracket for the right side of my drawer slide. The mAtkins on it are as follows: G * 6020-6 PH. The letter R is also on it- I'm assuming that means right side. Thank you!

Hello, I see at least half a dozen other people have uploaded a photo of the exact same piece I'm looking for. Has anyone ever figured out which part that you sell works the best? Please let me know. Best, Lance

Hi, Do you have suggestions on how to best fix the bottom of a drawer sagging or falling out?

Pat. 4930739

How do I remove drawers without breaking the slider? Do you have sliders to fit this furniture?

Hi, Several drawers in my kitchen are missing the back piece that is at the end of the guides and consequently, the drawers dip/won't stay level when I pull them out. I've attached pictures. Do you sell something that might work as a replacement and where might I buy them? Thank you! ... (cont.)

I need help identifying my slides. The part that mounts in the groove on the side of the drawer is approximately 13 3/4" x 5/8" and the part that mounts inside the dresser is approximately 12 1/4" x 3/8". They had a little plastic piece that housed the ball bearings. The only markings are TS-NO. 8. ... (cont.)

Thomasville Hall Chest SKU 82237-760 The (1/4" x 3") spring which is part of the self closing drawer rail is broken. Hoping to either replace the broken spring, or replace the entire drawer rail that includes the broken spring. Picture of drawer rail with broken spring is attached above. ... (cont.)

Need to locate part

hanging drawer slide socket and an adapter/extension. there are no markings on the parts. cabinets were installed in house in 1988.

What's the height as pointed out in the attached pic?

My current kitchen draw is about 20 years old and the rear bracket is broken and the draw fell down. The number on it says 2081/500.

Hi there, will the 32-018 rear drawer slide socket work with the 32-061 drawer slide and is there a London outlet or what time frame to get them delivered from your company? thank you, Hasso

I was given a dresser about 35 years old. Need new guides. Pictures included. PAT. No. on the current guide is 3,021,187. Company name listed on the guide: Ronthor Reiss Corp. NYC. Thank You Lorraine

I ordered 32-345 but it made my door a little too short. Should I be using 32-343? Here's a photo of the cabinet with 32-345 installed on the bottom and my original hinge on top, followed by a photo of the original hinge and finally your hinge. I hope you can help me get this fixed before Thank ... (cont.)

Thank you for sending the case runners so quickly. They were easy to install. I have a question, which I'm hoping you may be able to answer. After replacing the case runners, my drawers still won't close all the way. Do you know what might be causing this? When my drawers weren't closing, I n ... (cont.)

The plastic piece inside this hinge is breaking. We need replacement

I am looking for at least one of these hinges. Two would be fine. "Made in Germany" 699.265 53.20 I can send more photos if needed Thank you Angela J.