Viewing all customer Discussions for:

Drawer & Cabinet

Track says hdl. I need six left sockets.

Hi there I am looking for 9 of these white plastic glides that have the following on them: R-26. Pat 2857233 Any help is appreciated.

Not sure how to measure to make sure it's the same as the one I'm trying to replace

This is a picture of my cupboard hinges, will one of your experts see if you would have them. I need 4 for sure unless they come in sets then 2 sets. Thanks

Do you have one of these. Thank you, John

China made furniture with drawer pulls at 2" and 1 1/2" centers.

this attaches to the drawer, and has a slot for the slide. 2 are needed for each drawer.

The broken bracket in the back of the cabinet appears to be glued. Are the replacement brackets to be glued or screwed. Thanks.

I need 6 of the 32-125 Drawer Stops. Do they include screws and how many are in a package?

Need opppsite

What are the hole dimensions from the "heel" of the hinge to the 3 holes on the door side of the hinge? The hinges I want to replace measure 5/8" to the 1st. 2 holes and 1 1/8 " to the third hole. J. Renehan

Corner folding cabinet door. Left side hinges (2). Markings on door mounted hinge part; Made in Austria. Numbers 666.265. and 78.00. Cast iron part on door mounted hinge stamped with numbers 591.290 and 00/00. Also letter X on same cast iron part but in different location from numbers. ... (cont.)

53 x 31. The attached picture is the only thing I have been able to find that looks anything like what I need.

Hi, I am looking purchase slider brackets for my cabinets. The sliders were manufactured by Accuride. The plastic brackets are in need of replacement. I have measured the bracket at 2 15/16 inches tall and 1 7/8 inches wide. The sliding cap measures (from the outside) 1 5/8 inches tall and 1/2 i ... (cont.)

Looking for turn cams for prefab cabinets

I have a UNIGRASS 6600 drawer slides - 22 inch white - and need to a few rear rail mounts. I see from your site that is your part no. 32-119. What is the part no for the 22 inch metal drawer slides??

Hi, What is the part called that needs to be attached on the bottom of the drawer to slide onto the track?

Tried gluing this broken socket a couple of times, but it didn't hold for long. Cabinetry is 23 yrs old and I have searched high and low for a matching socket to no avail. The opening for the drawer slide is 1" high x .4" wide. Left hand side.

The hinges i am looking for are for the fold in the corner door it says 115 degree and has the number BT408B etched on the inside. sure hope you can help either finding this old part or a comparable replacement. Thank You

Small roller has an oring on it. These are from a steelcase desk with a rivited plate reading F-33683. No other identifying names or plaques.