Viewing all customer Discussions for:

Drawer & Cabinet

Hello and hope you are doing well! I am trying to locate replacement 3 inch drawer pulls same as or similar to the hardware shown in the picture. This hardware is from a dresser purchased in the late 1990's or early 2000's. If you can locate the same or similar pull, that would be great! I am in ... (cont.)

Need this fixture that the drawer fits into

I only have this one picture of the original hinge. Friend wants to replace a few of these with self closing version in a silver or shiny light gray color.

I have a blum hinge with a part number 20 610-03. (I think that is the number, it's kind of hard to read so I am not sure about the leading digit of 2.) The image I posted is a removable plate with a number 032-01. I just want to replace the plate because one of them broke (the image shows the compl ... (cont.)

We are renovating our rental. The kitchen cabinets and drawers are 50 years old. I am looking for this part that stops the drawer from coming completely out. Thank you !

I have 3 drawers that broke and the parts that were used where all like this. While the cabinet slide is not broken, I want to find the drawer slide rail (I may use the term incorrectly, but I am looking for the piece that is attached to the pull out drawer) that will fit this cabinet slide. This ca ... (cont.)

Please let me know if you have this hardware.

Trying to replace this bracket. Ok if there is not an identical match.

These hinges are from a crate and barrel tate bar cabinet. They don't have any names of markings on them.

This dresser was purchased April 9, 1974 and the stock number was 3-6220, but I don't know if that was the Davis and Shaw furniture company number or if that was Henredon's number. The pull I need is a bail type with a center to center spacing of 6 inches. Attached is a photo.

I have Amerock hinges on my cabinets in my double wide Palm Harbor home. The number on it is 2010-31. I found 2010-33. Are they compatible? Do you know if there is an updated number for my part? The home is 15 years old. Any suggestions are appreciated.

Grass 625081

I bought a few sets of these soft close hinges to replace the existing ones I have. The screw holes are off and I am wondering if I have the right hinge. If this is the right hinge, is there any adjustment I can make.thank you,Julie

Made by Amerock, Burnished brass, #3 stamp Made in the 1990's

Looking for replacement parts for both the right and left plastic rear slide mounts. the cabinets were made by Wellborn and, according to them, the mounting assembly was made by Grass. There are no obvious markings except the 2 parts are identified with "Right" and "Left" at the top of the parts. Th ... (cont.)

Need replacements

I am after 6743055300 kitchen cupboard hinges. Can you tell me what I can use to replace them and what degree they will open eg110 degrees. Will you supply me. Thanks Beric

I am in search of pulls for my antique Sellers cabinet. It came with three whole and one broken. I would very much like to find original.

Need a guide for my dresser drawer. The opening of the guide is 1 3/8 inches wide to fit the drawer rail that is 1 1/4 inches wide and 1/4 inch high. Pennsylvania house dresser.Thank you for your help.Peter

It has a roller on the track and an unusually shaped drawer stop. Thank you