Viewing all customer Discussions for:

Drawer & Cabinet

Made by Amerock, Burnished brass, #3 stamp Made in the 1990's

Looking for replacement parts for both the right and left plastic rear slide mounts. the cabinets were made by Wellborn and, according to them, the mounting assembly was made by Grass. There are no obvious markings except the 2 parts are identified with "Right" and "Left" at the top of the parts. Th ... (cont.)

Need replacements

The part of the hinge that fastens to the door lost a plastic piece. Now when the door closes, the hinge makes a snapping noise where before it was silent. We need to replace the half that fastens to the door. The hole is 1 3/8 inch in diameter. The screws are 1 3/4 inches apart. There are several s ... (cont.)

I am after 6743055300 kitchen cupboard hinges. Can you tell me what I can use to replace them and what degree they will open eg110 degrees. Will you supply me. Thanks Beric

I am in search of pulls for my antique Sellers cabinet. It came with three whole and one broken. I would very much like to find original.

Need a guide for my dresser drawer. The opening of the guide is 1 3/8 inches wide to fit the drawer rail that is 1 1/4 inches wide and 1/4 inch high. Pennsylvania house dresser.Thank you for your help.Peter

It has a roller on the track and an unusually shaped drawer stop. Thank you

Handle is antique brass with oak wood insert

The identification on it is; Austria Grass 348Where can I purchase a replacement hinge?Tom Thank you

Need to replace one of these hinges can't seem to find them online. 2 3/8th on both sides.

Hi, seeing if you guys have this. House built in 1989 and looks lpretty or we have sliding my door screens from you guys and window cranks. Hoping this is from your company as well. Piece is made in Germany.

Hello, 3 of 4 drawers from one of my cabinets are off track. From what I can see, the glide is broken. Would you please advise if it's possible to fix? In the attached pic of the drawer, the top drawer is missing glide, and bottom one is intact.

Per phonr call last week,I was told that you have only one drawer hardware that fits in the middle of the bottom of the drawer. Part # ???? My drawwer is 16" from front to back. please give me the part nuimber. Don

Hello, I'm in need of 2 rear brackets as show here. Is this something you could possibly get? Thanks! Matt

I need the part that is in HASSpic1 on the right hand side. The other pic shows the existing bracket to snap into, next to a working draw rail. Manufacturer is HAAS. Thanks Dave

Hi! My family and I have tried to find a replacement hinge for our cabinets for months. We have recently tried the "110-Degree 35 mm Full Overlay Soft Close Frameless Cabinet Hinges with Installation Screws" from home depot but we think it would've fit if it was longer. Please help! We have resorted ... (cont.)

I'm looking to replace this draw glider.

I don't know the cabinet brand but this bracket has snapped and no longer supports the track. Do yoi have this part or can you tell me where I can get it? If not, do you have something comparable? I will want to buy 6 pairs of left and right, because I expect this to happen again with other drawers. ... (cont.)

Good morning. This morning I returned my original order to you. Hinges 32-349 did not work. I have sent pictures of my existing hinges (mepla hinge 697.043.59.00) that are on my corner cabinet. I hope that they will help in identifying the proper hinge. Any assistance you can provide would be g ... (cont.)