Viewing all customer Discussions for:

Drawer & Cabinet

track back plate has broken so there is no suport for the side rail. I think maybe I need 32-089? My side rail is 1" wide. The back plate is broken in a couple of drawers--1 is a kitchen utensil drawer that is about 22" deep and other is a desk drawer that is about 16" deep but except for the len ... (cont.)

This piece attaches to the cabinet and allows the track for the drawer to slide in and hang.

I need 10 replacement hinges. See photo. Hinge number is: 03087.67 Thank you!

I would like to get a replacement for the attached picture of my broken bracket

Looking for a replacement holder for the right side of the drawer. One picture is broken one and other is still good.

Hi,Im looking for a replacement for this kitchen cabinet hinge do you have a replacementMepla Hinge 698.243.59.00 Thank you,Hany

hi I am trying find a replacement for a broken corner cabinet door hinge. I am including the pictures from my cabinet and an image of the actual broken hinge displaying the letter. Please let me know which hinge will fit this door. Thank you Krishna.

Looking for the amber colored plastic retaining clips for my 90 year old mother's curio cabinet. (Not the plastic ones) They hold the vertical glass panels in place. Mom lives in Canada.

I believe these are 1 1/4" overlay Grass hinges. Not sure how far they swing open but it's a pretty long throw. The number on the Grass hinge is 860-02. Any help finding a replacement hinge is greatly appreciated. Thanks! ~ Jim

Trying to find a replacement,part of hinge broke off where screw is. hinge is about 35 years old. Thank you in advance for your help. Anne

I need a few rear slide mounts older yorktowne cabinets

I'm looking for these drawer guides for my 1997 chest.

I had conversation with you earlier. As requested these are pictures of cabinet hinges.

I need to replace this hinge

Do you carry a shelf bracket with a 3/8" diameter post??? Thanks, Doug

Morning I need These draw part. Do you have it?

Looking for p/n for a rear press-in drawer slide mount (plastic piece) as seen above in the picture.

The clip show Dynamic NT part 793.070. But the Slider is bent. I can see a code VA 500 AJ CI on the slider.

Do you carry this?

I am looking to repair a couple drawers and need 2 each of left and right mounts. Pictures included. Do you have something with a 3/8" x 1" receiver slot?