Viewing all customer Discussions for:

Drawer & Cabinet

I need 1 5027474 concealed hinge. Your 32-345 looks like it might work without having to drill new holes in the cabinet door. Please advise.

The above part has a maximum opening of 1 1/4". It glides over part 32-076 (Kenlin Case Runner) Can you identify a compatible part? I could use a few.

I have tracks but need clips for 1 shelf and 2 / 16" pullout sets brackets, clips and wood pullouts please call me. my name Rose

See pic attached Do you sell the broken piece?

Photos attached I need replacement drawer glide back supports.

I am looking to purchase 2 of this hinge Do you carry them ? If not, where can I get them in USA ?

this is a drawer guide stop that mounts to the horizontal rail underneath a cabinet drawer. There are no names, numbers or markings on any part of this drawer guide. The pictures make it look shorter than it is. The piece measures 1" wide by 9/16" deep with varying widths. Product Code: 32-078 i ... (cont.)

need two cabinet hinges for my corner lazy suesan bi doors.

Need a replacement hinge for a console cabinet purchased from Costco.

I need 1 replacement hinge like this, that has the quick release button on end.

Need replacement slides for trash drawer

As you can see there is a crack in the center support. Kitchen cabinets are 1998 vintage. Underneath is a strong support on the center pole in fine shape. Hoping you have the part or suggestions.

These stops fit over the back of the drawer at the corner & are held on by a staple. Some were missing after it was moved. Thanks for any help.

The pictures are of a 5-Drawer dresser over 50 years old. The Drawer tracks were wooden. The drawer guides, metal. As you can see both need replaced. Your 32-053 replacement kit would work perfectly for the tracks, however several of the guides are also broken like the one on the left in Drawer 2. ... (cont.)

Looking for a bail pull 4 1/2 center to center oil rubbed bronze. From a universal chest of drawers. Pull tab s have broken off

Need help diagnosing problem with a drawer that only goes in as far as the slider that is mounted to the inside of the desk hits the end/stop near the back of drawer. Photos attached. Drawer closed fine until it was recently removed to lighten the desk for moving.

hi there, i have two different types of floor to ceiling old metal closet doors. i need to install them but i'm unsure which pieces they both need. i redid the floors so i'd love to have them only need a track on the top if possible. the height is about 94" tall and the width of each closet is aroun ... (cont.)

Betsy Cameron Lexington drawer sockets

Assuming this hinge is Amerock because it has listed on it an "A" along with the number 8701

Has a number H-1013 stamped on it 4 1/4 inches tall 3/4 inch wide at bottom Slide is 1 inch tall and 3/8 inch wide