Viewing all customer Discussions for:

Drawer & Cabinet

I need 1 replacement hinge like this, that has the quick release button on end.

Need replacement slides for trash drawer

As you can see there is a crack in the center support. Kitchen cabinets are 1998 vintage. Underneath is a strong support on the center pole in fine shape. Hoping you have the part or suggestions.

These stops fit over the back of the drawer at the corner & are held on by a staple. Some were missing after it was moved. Thanks for any help.

The pictures are of a 5-Drawer dresser over 50 years old. The Drawer tracks were wooden. The drawer guides, metal. As you can see both need replaced. Your 32-053 replacement kit would work perfectly for the tracks, however several of the guides are also broken like the one on the left in Drawer 2. ... (cont.)

Looking for a bail pull 4 1/2 center to center oil rubbed bronze. From a universal chest of drawers. Pull tab s have broken off

Need help diagnosing problem with a drawer that only goes in as far as the slider that is mounted to the inside of the desk hits the end/stop near the back of drawer. Photos attached. Drawer closed fine until it was recently removed to lighten the desk for moving.

hi there, i have two different types of floor to ceiling old metal closet doors. i need to install them but i'm unsure which pieces they both need. i redid the floors so i'd love to have them only need a track on the top if possible. the height is about 94" tall and the width of each closet is aroun ... (cont.)

Betsy Cameron Lexington drawer sockets

Assuming this hinge is Amerock because it has listed on it an "A" along with the number 8701

Has a number H-1013 stamped on it 4 1/4 inches tall 3/4 inch wide at bottom Slide is 1 inch tall and 3/8 inch wide

I have a pair of Hettich hinges. Looks to be stamped 04666. Do you carry these? Thanks, Craig

Looking for some drawer guides that attach to back bottom drawer panel.

Looking for Merillat replacement parts for pullout Kitchen shelves

Looking to replace a Kitchen cabinet hinge. Below are the markings that are on it Lomepia High Point USA 698.243 59.00 Made in Austria 697.043.60.00 (on a plastic part) 511.243.01.92

Trying to find a replacement for Pat. 3613151 circa 1983. Lowes had similar, but was the self closing type (with that extra ledge). Do you have anything that matches in brushed nickle/chrome? I'm trying to avoid drilling new holes in over 30 cabinets. Thanks! Sherrie

1st pair needed for corner kitchen cabinet Replace broken Mepla, one side reads 53.20 664.265 Other side reads 346.290.88.00 sent pictures Second pair needed for bathroom cabinet door replace Amerirock, 2019E 5.0 MM sent pictures

Is there a replacement for the compression type hinge. Most that I've found requires screws to attach hinge to door. The wholes where the screws would go are very oversized. There is a word inside the round area of hinge "Toic" I believe? Hinges for kitchen trash cabinet are going bad home was buil ... (cont.)

Guide to attach rail to side of cabinet

Hello, Want to replace my draw slide. It's a kitchen cabinet I bought 17 years ago from Home Depot. The numbers I got off the draw sliders is 7523-19/470/457 06-48 made by Grass America. Do you have replacement parts?