Viewing all customer Discussions for:

Lavatory

Will your Shower Door Bottom Hook Guide 10-139 replace the Showerite PG-1 Panel Guide Clip? I have attached the Showerite parts info. Screws are 2" apart the unit is 1 1/2" high.

Hello, looking for replacement parts. The sliver strip with the black rubber came off of the bottom of shower door. It appears that some kind of adhesive is on the part of the silver strip that came off. Looking to replace the part that came off, silver strip with black rubber swepper. See attach ... (cont.)

Current shower doors are 40 years old. They outer door came off the track, I attempted many times to put the door back on the track but it would not stay. When I took a look at the door from inside the shower, I noticed that the metal plate that screws into the door (not the wheel) was cracked. I a ... (cont.)

I have a grand junction 2009 QSB, sent pictures of the rollers and a picture of the shower itself, I don't know if it is part number is 10-071 for a round shed, part 10-075, or part number 10-076, can you help me!! Thanks, Suzanne

How long is the slide bar?

this part secures the lower portion of the shower door for a maax centric framed corner square shower

My customers rollers keep poping out of the track

The shower door is loose at the bottom, what are the replacement parts for the parts shown in the picture? And also what is the shower sweep show I buy for this drip rail? Thanks!

I need new shower door sweep for old shower door. Made by Aquaglass and is 213/8 long and on with no screws. Do you anything I can use?

It's a 2 inch shower door handle. One side of the handle broke

I had a dela bypass bathtub door come of the rail and shatter. I thought I had retrieved all of the parts however I am missing one of the "grommets/spacers" (see pictured) that slides ove rthe top of the door and the large rollers are placed over. The delta hardware kit is also in attacjhed pictur ... (cont.)

Need a shower door sweep replacement with distance from end of door to screw of 2 1/2 inches

Greetings, What are the measurements of the magnet seal that is part of the "70 inch shower door magnet seal and end cap unit". Thanks

Does it come in 35"?

Hi, I got a corner shower cabin that I am unaware what brand it is. "tempered 16 cfr 1201-ii ansi z97.1-2004 1/4 ua sgcc 3960" That is all I could find. Can you help me find the part

I believe the 10-325 is what I need for the bottom of my shower door. There are two screw holes on the inside. The measurements are approximately 29 3/4 inches. Is it possible to trim the 10-325 without destroying it so it fits my door?

looking for the part (an end cap or stop) that stopes the glass door from sliding out horizontally off the track.

Hi , Bought the latch set item #10-553 and it's too large. Can you recommend the correct part for me. Thanks, Phil

Hello, I am looking to get a replacement lock for this bathroom door at our church.