Viewing all customer Discussions for:

Lavatory

Hello I am looking for this part, want to verify that you have this

Removing the old, broken roller assemblies from this corner shower unit was not an issue because the wheels were detached - i.e., they slid around the bent section and out of the track one at a time. With the new part, on which both wheels are permanently attached to the plastic assembly, I am unabl ... (cont.)

This part stops the sliding shower door from over extending to one side and having the wheels come off the track. This is a curved corner shower. These parts are in the the center of the top track and contact the wheels as a bump stop.

Do you have a pivot hinge for a shower door as shown in the two attached images. The base of the white acrylic/plastic hinge is about 1/4 inch wide. The hinge shown in the image is the top hinge. I need the same hinge for the bottom of the shower door. If you do not have the hinge, can you sug ... (cont.)

I need to buy a few of this type of door guides

Shower door hardware

Looking for new heavier rolls for my shower door. Picture attached

what are the dimensions of Product Code: 10-325

Hi there, I would like to replace this shower door hinge. Can you please help?

The rubbery-plastic pieces insert into the side channel of our shower doors. They keep the doors from bumping each other. They have become discolored. I think they were originally clear. Photo 4 is sideways as the channel actually runs vertical.

Does the 10-058 double roller take the place of a single bottom roller? If so, can we order just the bottom roller without ordering the whole kit? thanks for your help. Kathy & Carl

We need to replace the metal strip at the base of the shower door. Manufacturer is Naidraug. Door opens out with a handle. Door is 26 inches wide and 70 inches tall. Metal strip is 26 inches long and 1 inch wide. Strip has screws at ends. We also need the plastic door sweep part. ... (cont.)

My old part is only 24 inches long. Is this product easily cut to fit my shower? Also, does it need some sort of adhesive to stay in place?

Need replacement part please

Hi - Can you help with a seal/sweep for the bottom of a framed shower door? There are no marking on the door or the drip rail. Approximately 6 years old. Thanks

I have a customer looking for shower door parts. This is all the information I have.

Can you please identify them sell me two of these Jane

Need all the hardware (rollers). For a horse trailer shower door

need a roller or at least the wheel with the bearings in it. It goes to a Frontline Manufacturing Diamond series corner shower that is in my 5th wheel.

Good morning, and I hope you are all doing well. I tried to upload the attached photos to my parts inquiry on your website but was unsuccessful so am sending you this email. The broken top roller is for a curved glass Efron America shower door, and from I can tell the company is no longer in bus ... (cont.)