Viewing all customer Discussions for:

Lavatory

The only markings are on the glass itself and says; Tempered 16 cfr 1201 - II Ansi z97.1-2004 1/4a sgcc 3960

This bottom gasket is a T Type with the top of the T being about 1/2 inch. The metal rail is mounted from the bottom and it may not be easy to install one of your drip rails. Photo attached.

Looking for a replacement for this lock for a commercial bathroom stall.

Do I need to apply 1/2" waterproof double-sided tape between the sweep and my shower door before I screw it in?

Looking to replace 4 bumpers and one door divider on shower doors. Original manufacturers name is Showerite item number 150CN 59" frameless bypass tub doors

1996 Damon Daybreak shower door rollers are breaking. About half of them are gone and I need.to find replacements. The door itself is in good condition but the shower cannot be used until rollers are replaced. I did not find any identification on the rollers or the door. The last photo is the part t ... (cont.)

The magnet slides into the channel of the frame which is stationary (old rusty magnet is between the rubber slides). Magnet is 3"inches long, 3/16 height and 1/4 inch width (by my measurements). Magnet can be longer if needed. The last photo is of the shower door itself with the mate to the magnet w ... (cont.)

I am looking to replace my shower door sweep. It measures 25 1/2" and the part where the rubber is 24 1/2". One screw hole is about 1 3/8" from the end and the other is about 3" from the opposite end. Do you have this part? Thanks so much! Could not upload the photos - if you have an email I c ... (cont.)

Need 4 sliders for the bottom of my shower doors.

See above

need a stiff shower door sweep that matches this. I got a flimsy one from home depot and it did not stay on the door. Thanks for your help!

Shower is from 2002 The size of the sweep is 33?x 1 7/16? (top to bottom) Appears to be angled

I am looking for anchor that holds the roller onto the glass shower door A-S 3937 or It could be A-S 5937 ,the number is not clearly seen.

Hello: Part #10-133 looks like it's what I need but I just wanted to ask if it is a standard size. Also, the cheapest shipping cost is $6.95 or about half the cost of the part. Why is it so expensive.

Looking to replace this worn out sweep. Thanks!

I have a frameless shower door (Frmls Dr&Pnl,Pll,Wll,Nkl3/8 Cl,Mni

DIAMETER IS 1-5/8"

Please see the attached picture and advise if the 30" SHOWER SWEEP WITH DRIP RAIL Product Code: 10-325 will work. The dimensions seem to be the same; however my current sweep has three screws. Is this product the correct product to purchase?

Your drawings give all the dimensions except the slot the door fits in. The guides I'm replacing have 17/32" slots. I need some of these if the slots will accept my 1/2" door without too much play.

Is this hard plastic or is it plyable?