Viewing all customer Discussions for:

Lavatory

Please advise what shower door guide I need

Looking for these rollers. Need mostly for left hand door but would take sets for each door.

I am desperately seeking a replacement roller for the top right section of a corner sliding shower door. The manufacturer is Maax and I have been unable to get any response from them. I am selling my home and would like to eliminate this as a possible negative issue. Sorry the images are shown side ... (cont.)

Could you please let me know if you have the replacement rollers for our shower door? Thank you

3/8" shower door glass. Plastic broke where nail goes in.

need to know if you have the rollers and the leveling screw

Hello Do you have a replacement sweep for an old (30 years old) rubber door sweep for showerdoor? I measured and the width is 23 inches and it has 3 screw holes, which are kind of corroded over time and I?m hoping I can actually get them unscrewed in order to put the new sweep in. It?s antique bro ... (cont.)

Looking for a clear plastic shower door seal

I was looking to replace our shower door handles there are 2 inches between the Holes

Need a shower door bracket that looks like the picture

I am trying to find replacement hardware for an angled floating door. The second picture has the top piece I?m looking for and the first picture has the model info i found on the door track. Can you help? Thanks! David

Hello, The sliding shower door bottom guide is not fitted in my shower door. I measured my shower door bottom gap length is 5/16". However, the little part of right side of the sliding shower door bottom guide doesn't allowed that sliding shower door bottom guide fit into my shower door in photo.Do ... (cont.)

I figured out the part I need but I also have 2 broken wheels but no broken housing. Do you sell the wheels seperate? Here is the housing part i need to order 10-071. I need to know how to order the wheels to

do you have any sliding shower door rollers. Picture attached, notice the depth of where the roller goes against the bracket so the door does not rub against frame Sincerely, Jim

Hi, I'm looking for 4 replacements to the broken & bent roller brackets on my Keystone shower doors which have 3/8" glass doors. Can you help?? Thank you, Tony

Pictured is the seal I need to replace...it is 11 mm wide on the top flat part. The oval tube below the flat part is 10 mm wide at is widest side by side and top to bottom. The strip is about 4 feet long and snaps into a channel on the threshold of my shower entrance. Thanks !!

We need to figure out where to get this exact part if possible. The one we have is broken. We don't know where it's from. There are two screws, and a tiny bit of foam that help cushions the glass.

Holds roller to shower door

Shower door guide house built 2005 Del Webb Pulty

Trying to identify this shower door, it is damaged and I need to replace it, the only markings is the imprint on the glass which does not identify the maker nor part ID. Photos attached. Thanks!