Viewing all customer Discussions for:

Lavatory

do you have any sliding shower door rollers. Picture attached, notice the depth of where the roller goes against the bracket so the door does not rub against frame Sincerely, Jim

Hi, I'm looking for 4 replacements to the broken & bent roller brackets on my Keystone shower doors which have 3/8" glass doors. Can you help?? Thank you, Tony

Pictured is the seal I need to replace...it is 11 mm wide on the top flat part. The oval tube below the flat part is 10 mm wide at is widest side by side and top to bottom. The strip is about 4 feet long and snaps into a channel on the threshold of my shower entrance. Thanks !!

We need to figure out where to get this exact part if possible. The one we have is broken. We don't know where it's from. There are two screws, and a tiny bit of foam that help cushions the glass.

Holds roller to shower door

Shower door guide house built 2005 Del Webb Pulty

Trying to identify this shower door, it is damaged and I need to replace it, the only markings is the imprint on the glass which does not identify the maker nor part ID. Photos attached. Thanks!

need lower guides, part # 10040766

If parts to not fit are they returnable?

Shower Door Roller Parts 2008 Mobile Suites 36TK3 Vin# 81004080

Looking for assembly top and bottom for a magnolia round or talen (both Maax)shower

Looking to replace this broken part

I got the 10-133 part number off of one of the handles. The picture says 2 1/4 but mine seems to measure 2 inches.

I need to replace this rail and the rollers. I can get more pictures if needed. I could not find any numbers or a name on this shower door.

Attached here are photos of the guide that attaches to the bottom of the glagg panel shower door. I purchased these doors almost 20 years ago and do not know the manufacturer. One of the 2 guides that needs to be replaced is split in an even straight line running crosswise. I have not been able to ... (cont.)

Need 2 shower door bottom hook guides 2" x 1&1/2"

Hi,Attached is a photo of my situation. As you can see, the guide has no piece to divide the doors and therefor the flop in the channel. The channel is 1 5/8". Do you think you part: Product Code: 10-122, will solve my problem?Thank you,Gasper

Hello, Hoping you can identify this roller for a curved shower door. I don't have any stickers to identify the brand. Thanks for the helpShelby

Good Evening, I am looking for the rollers in picture attached. there are no names or numbers on anything that is visible.

Attached is the photo of the part needed for our shower sliding door.Bottom size is 2 3/8 . Mounting holes are 2 inches center to center. Wheel is 3/4 inch diameter. Height of bracket is 1 inch.