Viewing all customer Discussions for:

Lavatory

Hello, See photo attached. Do you have a replacement part like this? Many thanks, Toni

I need this part have one need three more that go inside of sliding door

I recently installed your 10-325 and found the installation easy to complete. After cutting the drip rail and drilling the holes, I am very pleased with the appearance of the new drip rail. However, the shower door is extremely tight and difficult to open and close. This tightness is very apparen ... (cont.)

your 10 058 Are the wheels 23MM Will the roller fit a 10MM hole in the glass. If you roller doesn't work where would you recommend I look? Thanks

I need 4 of these and I can use existing bar already the spacing is 2" on center of the hole and the opening of the bar holder is 3/4" x .25"

Do you sell this replacement?

I have new shower door and it won't stay closed. What can I do to fix it. Thank you

Bought a house and a few rollers are broke. Need to order the picture attached

1/4" glass, U part is 3/8 high. From left side of U to end of solid plastic angled drip lip is 3/4 wide. Rubber sweep is attached to angled plastic (different) . rubber sweep drops about 1/4 below bottom of U. About 26" long

Do you have this part and do you ship to Canada? We need 8 of them Thanks!

We ordered some replacement parts # 10-058 for our neoangle shower door-one of the bracket works great but the other one does not allow the door sit level so the door does not close properly, wheel closer to holes in glass 3/4 to far away, can you suggest any other part?

Need the top track to hang doors on

How do I put roller on

hi there I was going to replace this whole shower unit only because of the seals but I figured maybe I take a chance on just finding the seals first can you let me know if you can figure out what replacement parts I would need.. I also consider doing clear Glass, and if I purchase the clear glass ma ... (cont.)

Approximate size L - 6" H - 1.5" W - 1/4" ( one fourth) Frameless Shower door Bracket Quantity needed= 2 (two)

I'm looking for this replacement. Its 27.5 inches. Also here is a photo of my shower.

I am looking for a shower door sweep. the old neo-angle shower is about 23 years old. The pics above show the slot for the "T" sweep. It measures close to 7/16" wide.Thank you,Randy

We have a ANSIZ97 1-1984 King Glass corner shower. Two of the bottom clips are broken (see attached pics). Can you identify them and more importantly are you able to prove replacements?cheersRik

Bottom parts for 2 sliding shower doors.

Hello, I was looking at some parts on your site and I think I found a match for our top rollers. I need bottom rollers though. I'm sending some pictures. Hoping the pros can tell me what I need for the bottom of this shower. Thanks!