Viewing all customer Discussions for:

Lavatory

We found product # 10-597 that looks correct except for the width between the fins for the stall panel. Our panels are 1". Do you have a part that will fit?

I need to replace the bottom guide for my shower doors but am having trouble finding the correct replacement piece. The shower doors are 1/4 inch thick. The two screws are 1 1/2 inch apart . The plastic piece is 3 inches by 1 1/2 inches. Thank you,

Hi can i purchase just the wheel assembly or must i purchase the complete trolley assembly? Frank

This part is the roller on top of the shower door. I've photographed the good side. The other side has broken off. The part is labeled Allen Steven Corporation, A53937. If you can find this part, I would be grateful. Thanks. Tricia Newell

My shower sweep needs to be replaced. It's 23" long and the drill hole on the inner part of the seek is 3" from the end while the drill hole on the other side is 3 1/4" from the end. Can these be custom made by your company. Thanks Gary

Hi This might sound like a ridiculous question, but does the shower drip go on the inside or outside of the shower? Or does it matter? Thanks

I noticed on the 10-324 shower door sweep you recommend a screw size. Do you also recommend a double side bonding tape that can be used instead? If so do you have a part numbe? Thanks David

My contractor threw away the fasteners. Do you sell new fasteners? If so,which ones are they and how much? And what do I need to drill holes? Also, do I need to put a drop of silicone on the end to keep the water from rolling out? My old one had that. Thanks?

The clear rubber material is about an 1" on the longest side. I hope this looks familiar in some way. I can't find a similar cross section part. I can't find the door mfg either. Thank you. Dale

Hi there, I have a shower enclosure that carries the mark/make: Unitex Tempered ANSI Z97.1-1984 16 CFR 1201 11 SGCC-2575 1/4U The shower door won't close. I am looking for the magnet that goes on one side and the metal on the other side. Please see pictures attached. Thanks a l

I need to replace this because it is 15 years old and getting cracked. Karen Richardson

I've attempted to replace the sweep in my shower door. I used a 1-inch clear vinyl. The problem is that I have a large gap beneath the drip pan that remains even with the 1-inch sweep. Do you have a sweep that is much longer than a 1-inch? I've attached a photo of the sweep and of the remaining gap. ... (cont.)

This part fits on the bottom of a shower door helping it glide and stay in the frame. I need 4. I can not find replacements anywhere.

Thanks for your help

I have the following two problems: 1) I can not remove the clip from the track, whole or when broken in two. 2) Need two replacement clips Old clip is 1.5 x 3" aprox. Thank you Duke

does this come with the rubber sweep and if so what is the deminsion from bottom to top?

Any idea how to remove this old drip rail so that I can install your 10-325. The old one lets water leak out onto the floor.

I need a replacement for the part in pics 2 and 3. It fits onto the post in pic 4, which slides into the hole in pic 1. The post is 3/4" long. Please let me know if you need more info/pics. Thank you, Jason C

I have Accurate Partitions in our public restrooms. I'm trying to figure out if your 10-593 and -594 hinge brackets would work with my doors. Our door edges are rounded, but your brackets are square. Will that work? Thanks, Guy

Current sealing is not working well. Water is leaking past the seal and I assume this needs to be replaced. I am looking for a high quality replacement. Additionally current configuration has large gaps at either ends. Is there a better option to replace the hardware at the bottom to ensure end to e ... (cont.)