Viewing all customer Discussions for:

Lavatory

How many screws are required on yours?

I have a Shower Sweep w/drip rail that has came off of the shower door - probably the same item pictured in the 24" shower sweep w/drip rail image. What size screws do I need to reattach the sweep? All I will need are the screws, correct? Thanks!

I would like to know if your 30 inch drip kit will fit as my replacement shower. It is 30 inches but the screw holes are placed sporadically. First hike is 3.5 inches from end then next hole 9 inches from that hole then next hole is 15.5 inches away from 2nd hole.

i am ordering 6 of the 10-071 shower door roller assy. I need 1 of the companion u shaped hook for the bottom of the door. What do you have to fix a broken one? Thanks

Need shower seal replacement?

How far apart are the screw holes in the 30 inch shower sweep?

what is the difference between a swinging door sweep, hinged door sweep and regular shower door sweep?

Will this shower glide replace showerite PG-1 shower glides

The standard shower sweep that I can buy a Home Depot 3/8 is not stopping water from running under my shower door..Probably a bad install. Do they make a 3/8 shower sweep that is adjustable (can be cut to size)and is wider than the standard ones. Or one that can fit of the bottom of the shower door ... (cont.)

This is a 29" swinging glass door. Any clue on what I need to replace this strip with? Do I need to replace the whole bottom part after removing two screws?

Does an original installation & maintenance guide exist from ANY manufacturers that specify a SWISCO 10-216 glide? As pictured, my glide is very similar to the SWISCO 10-216 part. No door markings or labels remain, but shower door is 56 x 60 bypass believed to be original, mid-1980s build. Two glid ... (cont.)

Hello, I need to reseal my shower door, both along the bottom and the side where the door meets the frame. Hopefully the attached pics show enough. The bottom frame does not have any visible screws. The glass is 3/16" and the frame is 1/2". The gap between the glass and the frame at the side is 3 ... (cont.)

Looks to be longer than 1inch to stop water from coming out. Please advise! Thank you for your expertise! LJ

Hi could u help me find the correct shower door sweep When I went to clean it I pulled the plastic part out and it just kinda fell apart Went to Lowes they said I should buy new door My husband isn't very handy...but I still love him So I usually end up doing these things Any help would be gre ... (cont.)

Can I cut the 24 inch drip down to 21 inches to fit my door? Does it impede closing the door if correctly installed? Do you have a vertical drip guard for the hinged side of the shower door. Thanks. Jamie B.

Need to replace a part for a King Shower Door ~ Photo of roller/broken piece that needs to be replaced ~ an additional photo will follow this email. Please advise asap ~ shower door is broken ~ unable to be used ~ urgent repair needed.

I need to replace a black rubber sweep on a shower door. I do not know the door manufacturer. The sweep is about 3/4 of an inch wide and has a semi round about 1/8 in top. See photos. Where can I get the rubber sweep or do I need to replace the sweep holder also? Thanks! For your assistance. Don ... (cont.)

10-058 shower door roller replacements

It's for a shower door on a 2002 country coach magna, 43' tandem axle at rear