Viewing all customer Discussions for:

Other

7" total length.

This flush mounted plastic latch is broken - I need a replacement. I'm not sure exactly how this broken part is removed and the new part installed but I'll figure that out after I determine if a replacement part is available. THANKS Dan

Have an old glass slider. Handle on door says Viscount, not sure if that's the door handle manufacturer? Roller is 1 1/2. Can you suggest a replacement part number? Thanks

Hi there. I have a couple outdoor sheds (made by Tuff Shed) that have some gaps around the doors that cause air leaks, and water leak if it is rainy and windy. I've tried foam weatherstripping with some sucess. But I'd love to get a better seal if possible. Any suggestions would be greatly apprecia ... (cont.)

Unknown window. No markings on window

Their part # VPKDA 100 (white handle set) for sliding glass door.

Plastic spring loaded tilt latch for replacement double pane window.Enclosed photo identified series 8501 window.NFRC mfg code SIL. Please see enclosed photos for info.Looking for 10 pair of latches.ThanksAndre

It is 24 inch's in length can you send me the link what to order thank you

Current track is 60" long and rusted out. Which track would you suggest to replace this one or which would be compatible?

Please give me your Product Code for replacing 3330 channel balancers. The stamp on the old balancer is 3330 BSI. The channel length is 34". Thank you.

I have merilat cabinets installed in our home built in 2009.I am in need to replace hinges which are not working well.The numbers I find on the back left side 860 02 and beneath says Grass and 0609. Left side 5604 and beneath 956. I would need approximately 100 hinges. I would prefer sioft closing ... (cont.)

I keep finding locksets that are too big...I need one the size as shown in the picture attached, please advise. thank you.

I need to buy a new profile cylinder lock for my Anderson storm door-I found some on your site-but want to order the correct one-

Hello: Please help me identify the correct part numbers for the Windows lock and pivot bar so I can make the purchase from your website. Thank you

good morning; my steel folding doors are in very good shape,but the 4 corners(pins and bushings are worn out.) the doors were installed in my home about 1973 or so. The large number on the paper inside the door is ABAJGJ. Thank you Mark

Dear Sir/Madam - I would like to order Truth part to replace my window. Please guide me what item need to place an order. Photos uploaded as requested here.I really appreciate your guidance and help!Best regards Radha

I need 4 balancers for anderson windows manufactured in 1987. They are high performance wood d/h windows The balancers have the following numbers Balancer 1, D81 7#27 Balancer 2, e51 9#27 Balancer 3, G23 Balancer 4, N05 419

I have a few of these broken and need replaced. Can you identify?

Rear lock got disengaged. I wanna know how to reattach rod or take this apart?

It's 28.5 inches long. Spring is 16 inches. Block and tackle is 10.5 inches. Spring in .5 inches wide.