Viewing all customer Discussions for:

Other

Need replacement inside handle for EMCO forever door

This coil balance is not stamped, so I'm not sure what weight it is. Any guesses? The window is 35-1/2" x 35-1/2".

The photos featuring the tape measure, are metric scale. It seems that this wheel and bracket assembly was metal at one time, now the bracket is black plastic. The flat wheel is ball bearing. thank you for your help.

I need help identifying replacement channel balances for a non tilt window

1957 Ohio house no identifiers noted; Prefer folding handle if possible; 6 windows, 3 right and 3 left; straight bar Thank you!

sash balance 15 D B.S.I 16inches

I want to replace the door handle set for a Kolbe patio door. Can you tell me if you have a replacement set that I can order. I would prefer a finish in something like oil rubbed bronze. Thanks

Thank you

these drawer guides are from an old sears dresser, carry them?

can you help us identify this window latch? For an "EPI" window. thank you!

I have 2 crank handles that are cracked

stamp: 2650

I purchased one each of the 39-187 & 39-188 operators. These are shown with a 5" arm. The ones I need to replace are an older style and the arm only measures 4 3/8". What do I need to do to make these work? Or is there a direct replacement for these older operators? I have two(one right hand and ... (cont.)

There are no markings other than stainless steel and H=O. The overall installed length is 4-3/4 inches. There are 2 indented "stripes" at the edge of the hinge over the underlying spring location.

1 3/4 center to center screw set , 5 /16 square drive handle to handle

Hi, I need help identifying the correct balance for my window. I need a pair.

looking for the latch for the storm door in the attached photos. Doo you have one with a 1piece front side??

i purchased your 55-303, and it worked for two out of three of my windows. the third one that it did not work on had the glazing shown in my photo, on the right. i don't see an exact match for this in your catalog, can you source this part?

I am looking to identify a window tilt latch for a Harvey window. The top of the latch length is 2 5/16" and the width is 5/8". It is 3/8" thick. I've also attached a few photos. Any guidance would be great!

Need stainless roller replacement. The tabs broke on these