Viewing all customer Discussions for:

Other

I just moved into a condo and discovered after the fact that one of my windows is broken. Like a guillotine on the top and bottom. There is no branding on the window and finding anyone to repair it has been impossible. My condo association does not have documentation of when they were installed or b ... (cont.)

Hello, The pointed gear is missing two teeth. If that can be replaced I'd like that. If not, the entire operator. Thank you.

Hello,I am looking for balances for an Anderson Narrowline window 3046 from 1983,I did take out a balance and got some numbers off of it,they were very hard to see,but this is what I wrote down E 54 9#27 5 83 . Also had 11600-2 stamped on it.Would you be able to tell me what parts I need .I would l ... (cont.)

hi i need the missing piece of window part on the left of the window in the picture and the bottom piece. you can see it in the picture as it's black

This is from an MW wooden window circa 2000. The 2 inch long white plastic piece at the end of the spring is what I need to replace since it is broken on the other side. Also, the small metal rod that fits into the hole broke off of the sash. I will need to replace that as well.

Hello, Good Evening! I am trying to find a replacement channel balancer / spring for my window. LEFT side bar shows 26 3 IR CALDWELL and right side bar shows 26 3 JR CALDWELL. Could you help me identify the parts please? If you have any questions, I can be reached at 703 376 8511. Thank you, S ... (cont.)

Need to replace 4 locks of the above photo Please advise

There are no markings. Latch remains stationary. I believe it's an Anderson door.

looking for crank and arms and hardware to attach to window from inside the window opens on the left right side of window slides to the left

I need 4 of these

How do you remove the sash from a PGT SH800 window so the top sash guide can be replaced.

Found this one my window. ansi/aama 101-93 Series: 5100 DH-C20 Mst: 4776 Hi, I just want to make sure is the product S385-13 with 1220 would be the one that I need to replace my broken balance? Thanks Yee

It is basically part number 23-095 but the tail end (the one above the height adjustment screw) is horizontal not vertical. I need one because the wheel I have is shaved down. I just can't find this replacement part with the retaining screw hole horizontal .

Looking for this handle. It broke and I need to replace it. Any suggestions?

We are looking for a replacement lock for an EntryGard 6 Patio door.

Seems like your part number 58-173 is similarly sized, but mine are about 93" long. This is located between the two doors. Could you verify if this is the proper part? Thank you.

I need to replace the operator (12") on one of my windows as it has a broken shank that I cannot attach a crank to. For now I am using a screwdriver. Also need 3 replacement crank handles. These seem to be larger than what is typical nowadays and have a deeper hole to accomodate the 1" shaft on the ... (cont.)

Approximately 60 years old Killian Toronto Canada Syracuse NY ( on wheel )

Hello I was wondering if you had these window screen tab in stock?

Hello, am looking to replace the 2 coils on our vinyl sash window. Shoe is OK. Dimensions of the upper sash is 23.5x23. Photos attached. Please let me know if you can supply this part or need more information. Thank you!