Viewing all customer Discussions for:

Other

Found NO markings on metal slides (white) or mounts. Kitchen was remodeled in mid 1990s. Measures 2 1/16 long.

my balance has 19 2 stamped on the back. Would you help me id the part.Thanks, Dean

plate that screws to the inside of interior door handle

I need to replace the coil springs. This window is a Catalina H-R20-48x96. The mechanism is a Caldwell Quicktilt and is marked '7R' (see photo) The springs are marked '7LI'. I not see a similar spring on your website. What do you recommend?

Hello,This part attaches to the astrigal window pair bottom & rotates with the inside crank when closed (meshes within the slot)to move the internal mechanism rods to lock the windows tight. The crank out Hinges are TRUTH but I could not find this part.(It has no identifying number)The windows are ... (cont.)

Sorry, I have no information to identify this part other than the photo. This piece goes n the the bottom of the drawer. The rails slide into it. Thank you for your help!

I have PSH hardware on my storm door. Looking for all new brushed nickel set. Internals and all hardware. The numbers on the internal hardware is 1096 Thank you for your help

Need to replace a weather worn Cole Sewell door handle for a Forever Door, serial #04250090004 0001. See images

Do you carry truth window glass to repair the broken?? If not do you know. Were I can get it??

Looking to replace on of these

Hello. I'm trying to find some replacement parts for the windows in my house. All windows are double hung type. The windows and frames are wood. The track is vinyl with springs. The windows are tilt-in. The windows are 1997 vintage. I need to replace at least the Sash pivot bar and pivot lock assemb ... (cont.)

Trying to figure out the correct replacement Length of metal bar 30 inches I/D stamped into bar 29B Y Channel balance top. Winged 1 3/16 in long 11/16 in wide Channel balance bottom winged 1 1/16 in long 1 in wide Trying to find a compatible replacement Thanks Terry

Guys I am in need of window clips that hold the spring loaded track onto the window itself. I think the manufacture is Dixie building supplies

30 3 stamp

I need the left and right side latch for the combination window on a storm door. The parts have a"1878" posted on them. I need to know the parts, cost and shipping. Thanks Chris Rathe

Our window balance coil has broken into 2 pieces and we need to replace it. It has 6K stamped on it. Do you carry 6K or its equivalent?

I need replace all window rollers on my windows.. the full width from axle to axle is 1/2 inch..Need concave roller.

the lock handle I purchased is correct, its the Amesbury Truth # 82-086. but I did not order a replacement mortis lock for this unit. it seems the one currently in the door is worn out so the lock arm that comes out does not stay in the locked position when the key is turned back to remove the key. ... (cont.)

We have a milgard window and I need to replace the balancer. I have a part number ... 20-5 JX CMC 7 Do you carry the replacement for this?

The top bar is original. The bottom is replacement. It doesn't seem the replacement pin is long enough. Is this the correct replacement?