Viewing all customer Discussions for:

Other

I need some of these Ellison window locks/latches. Let me know if you have anything that will work. Thank you, DL

it is the piece of plastic trim that covers up where the adhesive is on the window. it snaps right in the metal frame. it about 1/4 in by 1/4 in.

Thanks for taking a look at this. I can tell you that there is a marking on the side at the center of the "T"- the number 2.

The crank system on our milgard casement windows has stopped working (appears like the internal gears are totally worn down). Would like to buy a replacement part and fix it.

Hello, The weatherseal I'm trying to match comes from a window with an aluminum frame - vintage 1970's. There are no marking on the window frames or the existing weatherseal that I can see. It's a piece that fits on the outside and brushes up against a sliding window panel to keep the weather out. ... (cont.)

Hi! I need to figure out which window balancers to purchase for my milgard windows.

HELP!!The lock on my patio door suddenly failed. The lock lever no longer operates (from locked to unlocked position) and I am unable to open the door. I noticed just today that the latch felt oddly "loose" and was starting to look for replacement latch parts when the complete failure occurred. ... (cont.)

This piece came out of my window. Any help in identifying the size is much appreciated. Thanks!

HelloI have a T.T. Beyrle door assembly PAT.NO.2923.036 SET P.A.2 (FEB. 2, 1960) that we need a new top offset pivot for. I have attached two pic.s of the Hinge needed. Any help on this would be greatly appreciated.Thank youRick

The identifying sticker is on top of door but completely weathered away. The glass can be swapped out for a screed door. Need to refresh a number of things: Handle & Lock Sweeps Weather seals Clear Plastic clips holding glass in place. Can you advise on the brand of door and the appropriate parts? ... (cont.)

This is what came out of my window sash. Note the upper housing has a piece missing from it. Looks like the bottom is 4lb and the top is 5lb, there were numbers on the springs that did correspond with the casings. Can the whole things be replaced, they look pretty worn and cracked, and what would th ... (cont.)

This is a gapco window. Part number stamped on the balance is 1530 It is 15"

The plastic for a few of these pivot shoes have broken and the spring has come out. I need your help identifying the replacement part. Thanks in advance!

I need to ID these parts on an old vinyl window Rt and lft flanking casements top and bottom hinges, sash track and operators. Thank you, Peter

the arm comes out

Hello, the part has a Texas state image with MDC stamped inside, its Total lenght is 2.5 inch and the with is 1 inch the screws are 1 3/8 on center apart. Any help finding 4 pairs would be appreciated.

We need balance and guides for our windows

Glass in slider shattered and we have the replacement glass but unable to locate the white vinyl seal/gasket that goes around the edge of the glass and then into the slider frame. Only information on the door panel is an insert that indicates ESP OF FLA. My contractor can't locate this material.glas ... (cont.)

metal only is 24" long I need to replace both side. From heavy hurricane impact window.Want to order ASAP Stamped number is 2375 Thankyou

It is 5 5/8. The window will not close.