Viewing all customer Discussions for:

Other

Markings large "V" below it "A" also need 2 latches #82-107

15" channel balance off of a philips window. 4 little dots at base of rod

Hi, I have two screen doors that open to the side. Where the screen doors meet in the middle the strips of plastic help seal the opening and not let flys in. Can you please let me know what part should I buy to replace it.

Hi I have a Larson door which had a bad lock. I damaged it while removing it and need the Mortice lock assembly plus new handles and trim The door has reg # 025982U 111980507 Hopefully you can Identify what I need to order Thanks Bob

Handles for windows

Please let me know if you have these

Plastic bracket/socket broke on drawer. Slides are cream colored, Blum w/ 220E500 , -11-16 stamped on them. 7/8" x 3/8" x 19 3/4". White plastic socket has 60.1961 stamped on it, and it is about 2 3/4" long. Assuming cabinets were installed in 1986.

Do you carry the replacement window regulator to replace the one I need as shown in the images attached??

The pivot bar is broken

I would like someone to help me identify the replacement part number for a Tilt Latch for my window. Also if someone could tell me the model number. I have attach photos of the sticker and Latch to be placed. Thank you Jim

I need to replace my patio door mortise lock, but the part that covers the latch is also broken. Is this called the keeper? The replacement ones I'm seeing online are flat, but the one in my door is not. What should I be searching for to find a replacement part?

Hello,I discovered this broken piece on my non tilting window that wasn't working properly. The metal part is 33" long not including the plastic pieces on both ends. As you can see the insides are old (house is about 20 yrs). I may even consider replacing the same piece in the window on the othe ... (cont.)

I have a #r24 927 1088 ballance that I need to replace, can you help

Hello - I am in need of three replacement door sweeps to fit my existing steel, wood core exterior doors. The sweep slides onto the door bottom where the door bottom has L shaped INWARD bends that fits onto the sweep edges. Do you have this replacement part? Thank you! Dave.

DANVID-1-97

The geared arm is 3 1/2" from center to tip. The clip arm is 4 7/16" The only marking are Truth and patent # 4 241.541 Patent 1982

These doors are approx 15 years old. Should the one top pin have a plastic bushing that slides in the track?

Ansi z97-1-1984 16cfr 1201 -II Sgcc 598 1/8u Numbers on the glass I have 4 sliders need to know what fits please

I have a single hung window that requires channel balances to be replaced. I have identified as follows: 1-length 28" 2-width 9/16" 3-depth 1-3/32" 4-ID stamped '2730' I am unsure of which item identification to request for replacement. I have additional photos which can be uploaded if necessary. ... (cont.)

The part of the weather strip that inserts into the groove/kerf is thicker than the weather stripping sold at typical hardware stores.