Viewing all customer Discussions for:

Other

Looking for the correct size balance to put in a Gorell G5305 series double hung window size: 35 3/4" x 53 1/2" Thanks!!

I'm not sure what this part is called. It connects the window pane to the sash shoe.

Please identify these 2 parts for me to order thanks!

the lever cracked in half the door is in locked position I cannot open the door The door is a pella about twelve years old

I need 2 of these, only 1 plastic roller broke but I though I would replace both on 1 door

My patio door has an identifier of SGD-C25. I believe it has two single wheel rollers that are worn out.

We need a replacement for the white handle that closes the window. Please contact me as soon as possible.

Looking to buy replacement sash balancers

Need to identify part to go with my last purchase of 380 Channel Balances. 1.75"h x widest (top) 7/8"w ? narrowest 5/8"w The one I ordered is not correct. Please see photo showing: front | side | back of what I need. Thank you Vanessa

Please see attached picture off my hardware for my screens and advise if you have them.Thank you!

I am not completely sure, but it looks like your part 15-195

These hinges needs replaced and are located on the bathroom vanity doors (2) and all kitchen cabinets. (24) If you have the replacement is there a discount for bulk purchases?Thank you,Kevin

Where do you get the plastic bracket that holds the opening rod from the operator in place. It is held in by two screws, approximately 1.5 x1.5 inches and has an approximately 3/4 inch collar centered in the bracket.

Note the short section about 2 1/2 inches or so and the longer section of the arm that has a clip on the end. This is about 8 inches. Anything close to that? Manufactured around 2005 Andersen. Thanks

Hi, I have a vintage mortise lock or Marks with a stripped cylinder set screw. It's brass and approximately 2" in length x 3/8". I believe it could be a 91A. I'm in Louisville, KY and having a difficult time locating this. I searched Habitat as they sometimes have mortise locks and supplies. Thank ... (cont.)

I need 2 of these window pivot pins. I cant find a brand anywhere on the windows to help narrow down a pin. Hopefully you can help even if I have to modify it slightly. Thank you Mark W

Because the side of my housing say 10, I should chose a 10 pound spring right? But the series 160 is 1/2 in and my stock spring is 1/4 in.

I need new weatherstripping for m Stanley entry door. Your part# 58-008 look to be correct but my door width is 42 inches. Can you help Thanks Dave

Here are some photos of the mirror roller door, with an undamaged unit, + the incorrect one received yesterday, as per my other email, stamped on the correct part is "Stanley 17-4116", which I assume is the part number for Stanley- Monarch (spelling??) ? Harry

Please call me