Viewing all customer Discussions for:

Other

trying to find 2 bottom sliding latches made by lark

Hi,My name is Ed and I own a six story brick residential building in Brooklyn Heights, NY. The building was built in 1937 and has the original steel crank windows and doors. I am trying to replace a number of crank-to-open window openers that have varying lengths and widths. I am sending you a set ... (cont.)

I need a slide that fits in the track of a Polaris replacement window. I purchased the shaft that fits in the bottom of the wi dow from you within the last year.

Hello, My paper-wrapped tube of Slider Sticker is very difficult to use. It crumbles all over rather than coating lightly the runners of my patio door or my vinyl windows. It works if one can deal with the mess but I'm wondering if this is the way it is meant to perform when you apply it. I'll ... (cont.)

Hi. One of my sash balancer's is broken. the engraving is Anderson 356 4#19 12-80 (I presume manuf December 1980) 11600-2 What replacement part # do I need?

14 1/2 inch arm including gear

Truth operator marked 30905 on arm. Small link measures 5 inches. Need right operator.

Hello,CAn you recommend a part to replace this broken latch? As you can see, someone forced the door when it was locked and broke the frame. Do you have any type of part that could be used to make the latch area larger?Thank youBob

My French door glazing is failing and needs replaced. The pic above is a sketch of the cross section. Can you identify the part?

Need to find replacment for this tilt window latch

Please look at drawing and the measurements and let me know so we can get these latches ordered i close on this house in two weeks.thank you,John

Defiinitly a broken pivot bar from an ambassador window now out of business.I believe it's your 26-450 measurements seem to be close.The rest of the pin is still in the window hopefully I can get the window apart to replace it everything is sealed, thanks Randy

What track should I order . Picture included.

Here are pictures of the window balancers. I need two new ones.

3/8 inch glass shower door seals need replacement, cracked, one has a soft lip and other lip is hard. Lengths needed are 68 inches on hard side and 64 inches on soft side due to hinges

Hello, I have an old (1980s) kitchen window and it has a crank assembly that I cannot seem to find replacement parts for. Do you have an idea of what this assembly is or if there is another one that can be used in its place? Thank you for your help.

Can't find any thing close ?

Can you help me identify the replacement option?

I need a window track which will accommodate an offset single arm operator, part # 39-413. The diameter of the wheel at the end of the arm is 9/16. I previously purchased a channel guide (track) from you #39-504, however, the track is not wide enough.

Could you please identify this part? I need to order two and replace, if possible. If you have the part, will it also come with some type of installation instructions?