Viewing all customer Discussions for:

Other

Need a couple replacement Bonneville casement window crank arms. These are from windows installed in 2003.

The steel channel is 25 inches long and five days of an inch deep. One side of the window failed when the rivet holding the spring bent and pulled itself out of the holes which held it. Of course I'm going to be replacing both sides of the window. As best I can tell my son and I installed Windows 2 ... (cont.)

I need to replace both of my balances for my Viking window.

Hi. I was inquiring as to whether you have this patio door handle. Stanley PAT 963505?

I am looking for the bracket circled in the picture. It attaches to the back wall of the inside of the desk to allow the drawer to roll. I have the long arm Mary

Roughly 12.5" from end to end, recessed into the door. I am not sure if I need a new mortise or a new lock/handle. The door lock needs to be jiggled up and down for it to unlock. Any ideas on what needs replaced? thanks!

Hi do you have this door handle replacement? It is 13" long and the screw holes are 12" apart. I think the top screw broke/ripped

Truth Hardware 10" 2 Right Swing 1 Left Swing

Hi, I'm looking for a 96" bottom concave roller track for closet doors with mirror. I need three of them. Based on your website the company used to sell them but no longer carries them. Do you have any alternatives or a lead on where I can find them? Thank you. -Rosie

Hello, the outside portion of the sliding patio door handle broke off. The sliding door is heavy and needs a good quality handle. do you have a suggested replacement. thank you

The inside handle broke off. All other parts seem to be fine.

serial #584858; door installed 2001 cover plate is 8 x 1-5/16" 3-3/4" between centers of handle and lock shafts

The parts that slides through the track were broken

Hello, I need to identify the correct part number to replace four Sash balance for an Anderson windows from 1980s. thanks

Need help identifying this roller it measures 3" by 2"

I need help identifying this part please! Thank you!

I am looking for a replacement for an old storm door door handle set. The only marking is "SECURITY. The openiing in the door is 1.25 inches in diameter. The distance between screws is approx 1/8 inches. This is a very old storm door

Good Afternoon, Could you please tell me what parts I need to repair this sliding door? I appreciate your help. Kind Regards, Fred

Please identify this part.

Looking to replace the 3-piece handle / lock system. Any assistance on the correct replacement parts would be appreciated. Thank you.