Viewing all customer Discussions for:

Other

The windows tilt in for cleaning. They are single hung, slide up windows. I simply need to replace the latches in order for the windows to open. Thank You

I need to replace switch lock, it went down the door frame

I'm looking for the lower sash tilt locks for Silverline windows.

Found a label that says the following: MFR: ELL-1 Series: 200 SH/DW(712/713)

In looking through your catalog I can't find a part that looks like this one.

Window cranks/operators. My name is Darryl I sent pictures of the old window cranks The measurements are the exact same measurements as 39-317 And 39 - 318. However the old ones I have are bronze. The ones you sell as a replacement are white. My old ones are Square and yours or rounded. Do y ... (cont.)

I need to get 2 for the left and 2 for the right

I need a new back plate for my slider door. How do I get one.

This is a 35" x 3/8" balance from a SuperSeal window installed in 2003. There is no identifying markings or colors.

It's a reg block and tackle but with a a part at the bottom with the part for the. Tilt part

latch catch with above number

Hi - These are vinyl screen clips. I've been told they aren't made anymore - I'm hoping you can tell me what I can order to replace them. The last time I ordered them from Pickens Windows in Ohio, the part number was F282BEIGE. There are no markings or numbers on the clips. Any assistance would b ... (cont.)

The interior of the lock broke off

Do you have a bug flap like this one which is just a bit over 2" long?

I have an old Leigh Metal Bifold door that needs a new bottom track, cap and bumper. Approximate measurements for the existing track are: Length 3' Width 1" Height 15/16". Would your Part 21-401 track be an acceptable replacement and what other parts would I need to finish the set up for the new tra ... (cont.)

Windows are from 1965, this is hard plastic, grey, total height, 9/16. 3/8 wide from window groove to edge. 1/8" snap in loop.

Hi folks, Greetings! We're looking to replace some balances. The bottom shoe, however, has a width of 1 1/16", so I don't know if we should use the 15-001 or 15-002 shoe. What is your recommendation? Thanks much, John :)

I have a small shower with curved sliding doors. One of the bolts on one of the doors is broken.Images 8647, 8648 and 8649 are of the bolts that are not broken. Image 8650 is of the bolt that is broken; part of it is missing.Etched on the glass is the following:CAN/CGSB-12 1-M 16 CFR 1201 C11ANSI ... (cont.)

The coils have 440 stamped on them. Can you steer me in the right direction? Thank you very much!!!!!

I am looking for a replacement window opener. It is an old Anderson Flexivent window. I believe the Anderson part number is 0333908. It is operated by a lever and not a crank.