Viewing all customer Discussions for:

Other

we are in need of 28 replacement clips for the window models in the subject. Can you please let us know where we can get them? Thank you

I Cannot find the specific part. instead i bought 23-086. I want to know if it's fit.

Hi which part would you reccomend bases off the attached pictures? The part is 16" end to end. I would like to buy a new one

we need a 47" 58" and a 70" 4inch wide track

I have hinges that are stamped PAT 1967 CAN. These hinges are being used on raised panel doors where the edges of the doors are back beveled approx 30 degrees

I need two plastic lock covers. It is about 2" long and less than an inch wide with a square opening on the bottom at one end that fits over the square peg in the window. The cover turns to open and lock the windows.

need 31" and 39" balance with 19-004 top guide for rollyson widow

I have a bearing that broke unfortunatly the staple went through part of the designation all I can see is R-40_2 the patent # 3207187. If you point me to a vendor or sell direct either way I'm tired of having it fall out. Thank you.

I need to find out if you have these balancers and if so $$. Also, want to know if i can get at local hardware store. Thanks Mike

Do you carry this model?

Have a 24" long block and tackle ballancer needs to be replaced

The handle holding protruding "plug" on top, through which the connecting screw to the handle on other side connects is broken off. the model # are series; 5621/5631 AAMA /NWWDA 101/I.S. 1-97 SGD-C30-96X96 SGD-R20-189X96 SGD-R20-141X96

Looking to replace a missing vertical vinyl glazing bead on a Louisiana Pacific window. Attached picture is a snapshot of LP stamp on one of the windows, house was built in 1997.

how do i know what length to use on window channels . they were replaced years ago . but never worked correctly. now they all have sprung..

Tried filling out form it would not send so I was directed to customer care. See attached pictures Windows will not open or close easily. The window frame is metal with hurricane glass. The sash weighs 30 pounds. I am not sure the correct balancers were used upon installation of the windows. W ... (cont.)

The Weathershield spring is stamped 32R. It was most difficult to remove, is there a better replacement? Dan S.

One balance broken. Other side likely to need replacement. Another window balances same size probably should be replaced.

Have a PPG Herculite (#'s BS 6206-1981-A and 16CFR1201/C11). Need to purchase complete handle/latch/receiver assembly. Where do I go?

I'm not sure which model I should buy for my window channel balance. The stamp says "26 5 GV CMC 7" as the photo shows.

My window channel has a 26-4 stamp on it