Viewing all customer Discussions for:

Other

1

My tilt latch looks a little different from latch 26-243- 26-244 A bit longer -top and back different thinner? MGF simonton

Cracked part Approximately 12.5 inches long A Swisco rep pointed to the 82260. I don't know if it will work. Can you make it front facing like the other is? Not sure if this matches up with your replacement part

We have a window that doesn't stay open. We were able to get this channel balance out. It is rusted and broken. The only markings we see are 28D BSI R6/RG? We are looking to replace both sides of the window. Could you please direct us to which part/parts to order.Thank you, Jeff

Hello, 1992 Pado Emco door handle no longer works. Can you suggest a good replacement? Also, I would perfer brushed or satin nickle instead. Thank you very much - glh

Gear worn out for crank on Windsor awning window

I want to buy six of them but I need to be sure which parts I need .

I need to order several awning type window cranks. This is the info from the operator and attached is a picture of the operator and a dimensional sketch. RH, RD 1963 CAN, PAT No D-198202

My cutlery drawer broke, this white piece holds the glider arm that the drawer rests on. It clips to the back wall of the cabinet Has RSI written on it Any suggestions

Unable to locate part.

My sliding glass doors have a gap at the bottom and top of each door and are each missing like the plugs that are on the fixed part of the door that seal the inside from the outside. I can tell on another sliding glass door it has a like styrofoam plastic piece that is seals the gap - if there's no ... (cont.)

where can I purchase screen clips in GallatinTN

Looking for replacement part. Sweep portion on another door (not shown here) is ripped.

I'm looking to replace a broken plastic part for our kitchen drawer. (we need two)Us Pat no 309066 2 Patented 2965 CANThank you for your help!-Beverly

36" by 80" storm security door and I need a replacement key or a new lock? The top says MTS USA and the numbers on the bottom are 323.

Please help with identifying this wheel that's from a Patio Sliding Door. I searched through your website and couldn't find the correct part. Please help. Thank You!

I'm looking for a window crank and operator cover for an Andersen window. This house was built in 1974. Thank you

Hello, This spindle came from overseas. The spindle appears to be approx 6MM X 100MM with a sleeve at the spring cassette. Assuming that sleeve coverts 6 to 7MM. I don't know the manufacturer.

These are custom screen doors. This section of the part fell out when we removed the screen from the track. I have not attempted to unscrew the mitered frame to see where this part broke off from up in the frame.If possible I would like to order new rollers but would like to have non metal rollers.C ... (cont.)

Window is 14 pounds I need I guess a kit, the spring the shoe and the shoe cover for this type