Viewing all customer Discussions for:

Other

This is a wheel for sliding window

I need a replacement for a kitchen cabinet drawer back bracket. Unfortunately, I do not have a model number for it. Would you have a similar back bracket?

Our commercial dbl front doors has one broken pivot and the other bottom door is bad also, I'd like to replace all 4 pivots. The numbers on the yellow post-it are roughly the dimensions of pivots in use now. Please let me know if you have these parts available thank you

Length of metal channel is 22 5/8" Stamp- 22 3 PK Unknown Window manufacturer Need 1- Balance

Hi! I have a Pella Wood French Door that needs a mortise lock set. Is a handle set rather than a knob available? I attached the sticker from the door. I don't even know where to begin. Thank you for your help!!

I need the wheels/axles for this window. I have 2 windows that are exactly the same. All wheels are missing

27" in length, stamped # 26 4, No. B 1462(these were hard to read), I need 2 of these

Here are the photos. Please let me know if you need more details. Looks like product codes: 82-259 or 82-239, however, it looks like my measurement from each bolt is around 5 3/8 and not 5 5/8. Also the top slope is different.

I believe this is a snap-in glazing. It came off of my vinyl window. I have a few other windows where this has cracked. I'd like to replace these. Do you have this part? The window is a DH-R35.

I am trying to replace the coils balance on a couple windows but cannot figure out which ones I need.

Hi there, I will appreciate your help to find the right replacement part for this broken sash lock. The egress window is 46" high x 27" wide. It is urgently needed. Let me know if you need anything else

I'm interested in two right-handed and two left-handed handle replacements with hardware if you have them. Thanks.

Jeld wen directed me to your company to find a replacement front facing keeper for a window. The spacing between the holes is 1 inch center to center. I previously ordered F 2738 through Amazon and the keeper appears to be sitting too high. I've attached a photo of the one I need. Want help wo ... (cont.)

Hello, I am trying to find weather stripping for the casement windows shown below. There are two windows and there is no markings on the window so I do not know the manufacturer. The windows are likely about 25 years old. Thank you in advance for any help to can provide in identifying the weather s ... (cont.)

I believe my tilt in window balance needs a new shoe clip. We purchased from Windowmart. I don't know the manufacturer. Attached is one picture of an attached shoe and the other where the balance is no longer attached to the shoe. Do you sell this type of part?

Hello? I have a curved shower door and I am looking for replacement parts. I believe the brand is peerless and the doors are about 10 years old. I need 4 new rollers that match the attached picture.

Would like replacement parts for the Pella door.

I need a pair of these please. I think the photos will tell you more than I can describe. Thank you!

Looking for a 36C product code S770-36. The one I'm replacing attaches at the top with a little bar, the one in your catalog uses a screw. Would I just remove the hanger now in place and use a screw for this one? Thanks for your help.

Hello Milgard Windows Looking for these Stops.... see attached pictures. Do you sell these? or know where I can source? Thank you Paul