Viewing all customer Discussions for:

Other

I need two plastic covers that go behind these cranks

Good Afternoon, This would be the entire channel along with the T-Lock balance shoe. I am hoping to purchase four of them. Please see the pictures attached or what the channel balances will look like. Thank you very much!

I need this pivot bar from a tilt window. The pin measures almost exactly 6mm wide x 4mm high, and the distance from the pin end to the screw hole is very close to 1.6875" (1 11/16").

single roller assembly mid 1960's arcadia door

Need to replace these Milgard Sliding door handles with white handles. They are 4 15/16". Doors are 8' high.

shoe size is 1-1/16 (measured with caliper), it puts it between 380 and 385 models. i wonder which one should i order and if i there are any additional tools i may need to replace balance. just in case, balance was installed (i guess) 23 years ago

It seems the width around 11 to 12 mm and length around 72-75 mm. Don't know the make

Not sure what to call the parts I need. There are no markings on them that I can find. Can you determine from the photos which parts I need?

I am looking for this hinge. Outdoor Kitchen Slow close Cabinet Hinge.

I need help replacing this particular push bar with hinge probably eight of them in total

Do you have this? I need a set of 2 Thank you.

I need a left hand tilt latch. I have installed hundreds of vinyl replacement window's but that a long time ago. I am very handy.

I have attempted to get these parts thru norandex but the process is insane to say the least. The length of the part is about 2-11/16". I have included pictures of the window ID and the part I am looking for. I need 6 sets of these to start out with.

I need this part it is about 22.5 in long and it is screwed to the drawer

The picture I sent should be sufficient to see what the part is

Help I have several of these that are broken on my windows. Hoping I can order replacements from you.

Need replacement latch for 2003 Certainteed window. I don't see anything similar on your site.

I found mark is unique 20-E-50, manufacturer ed in 1999

Need help identifying which balances I can purchase to replace these. stamped 26 4 BW CMC 4 metal channel is 27" long thank you

Hi There !I am looking for Window Channel Balance peplacements for bedroom window that slides up and down. pls refer to attached photos and detailsChannel length is 27 inchesMarking Details : 26 4 GV CMC 2pls advise exact product details so that I can order these. thanks ! Amit